【M&H MATSUSHIMA】Harness For Vehicles With Double-Use Blinker Pilot Lamp (Left & Right) Review

Convenient items that save you time and effort

Since the LED Blinker was made into a Hazard by the Pilot, it is a time saver, considering the time and effort required, rather than having a rectifying Diode, Wiring, Heat Shrink Tube, and Bullet Terminal.

In my case, I decided that making a wiring was better than machining a wiring for a vehicle in a small space, so I used broken T5Socket components to make a complete set.

Merit is that it can be returned to full normal when TroubleShoeing.
Demerit is that it takes a lot of time and effort to fit in a lot of wiring.

Please refer to the photos for reference. View detail

Easy

I bought this product for the pilot lamp of my Takekawa SquareLCDMeter, which I installed on my XR100R road spec. I also bought and installed the same product on my XLR80R when I changed the Pilot lamp and Blinker Valve to LED before.
The only thing you need to do is to interrupt the wiring and take out the earth, so if you have enough skill to do the Bullet Terminal at Electric Works Pliers, you can install it without much effort.
I always buy them when I need them because they save me the time and effort of selecting materials, mail-ordering, and making them myself, and I don't have to worry about the wire breaking. View detail

No problem if you have the knowledge.

I used it to convert my SDR200 to BlinkerLED and the Instruction Manual was good and easy to understand.
The point to be noted is that it doesn't work properly if it doesn't interrupt the wiring just before the Pilot lamp according to the Instruction Manual.
At first I was impatient because it didn't work properly. It would be better if it was a little cheaper. View detail

barely

I changed to Light Bulb Type LED and IC Winnings to Relay but still got hazard in spite of changing to IC Winnings. I found this product on the net and it worked perfectly. The URL I found for reference is https://daradara.site/entry/halogen-bulb-led-bulb-turn-signal View detail

Easy

When converting the Blinker to LED, the Blinker pilot lamp will be converted to a for Both With the Left and Right single light system, the blinker does not work properly
The quickest way is to pull the Valve on the Pilot lamp, but the risk of forgetting to turn it off is increased I will

This product has a resistor inside the Bullet Terminal, which can be connected to Blinker behaves normally

If you can do a little bit of electronics, it's easy to build something of the same caliber yourself, but if you can gather parts and tools, you'll be able to make it yourself The hassle of crafting with

I think it's a little bit expensive, but when you consider the time and effort involved, this product, which only needs to be installed, is a good and affordable solution I think
View detail