【WORKS QUALITY】custom seat Review

It feels like being too overly chilly, though - - -

The feet are very good. Just because Seat as a whole is too thin, it looks bad for me personally! This may be a matter of preference - - -

Although I have not run after installation yet, I will write comments on the diary later, so please refer to it. (Will it be helpful? View detail

It purchased to exchange of the normal seat. When it improved with the guide peg, it was, but a difference called [ whether it is because the riding position of VMAX is low and ] a difference was not felt from a basis. A degree of comfort of a she

It purchased to exchange of the normal seat.
When it improved with the guide peg, it was, but a difference called [ whether it is because the riding position of VMAX is low and ] a difference was not felt from a basis.
A degree of comfort of a sheet improves markedly compared with the sheet in which the middle of normal projected.
In the direction which runs a long distance, it is recommended.
a new article -- the price -- the place on which it was easy to slide, and a little expensive place are minus points at a little time of length. View detail

It is attachment at the 98 model vmax. The seat center part is rising like the saddle of horse riding in an authentic positive one, and the hips were painful with the mileage of about 100 km. This sheet is the form which cuts off that center secti

It is attachment at the 98 model vmax.
The seat center part is rising like the saddle of horse riding in an authentic positive one, and the hips were painful with the mileage of about 100 km.
This sheet is the form which cuts off that center section that was rising about 4 cm, and flattened it.
It became very comfortable about whether does an even portion spread and a load is distributed.
Since sheet width does not change, the improvement with a guide peg is seldom felt.
Although I was not worried, cautions may be necessity, when it cares with a guide peg and is purchased. View detail

It became good with [ some ] the guide peg by 5-cm down. Would it become a GANI crotch a little from normal? Since the mounting bracket to a main part must be diverted from normal, it is the shin. Since the portion inserted under a tank is metal w

It became good with [ some ] the guide peg by 5-cm down.
Would it become a GANI crotch a little from normal? Since the mounting bracket to a main part must be diverted from normal, it is the shin.
Since the portion inserted under a tank is metal when attaching it and a sheet to a main part, a crack is likely to go into a tank! It is better to devise just for a moment, as soon as it deletes by itself.
Appearance is very good!! View detail