【KITACO】EX Exhaust Spring Set Review
Since the Spring currently attached to the Yoshimura Muffler of Forza (MF08) had been extended, it purchased. It was an apt Size.
Since the Spring currently attached to the Yoshimura Muffler of Forza (MF08) had been extended, it purchased. It was an apt Size.
Responses
Other reviews
Genuine Kitaco Exhaust Spring Set 75mm
I started with a new project that I have not tried before, a Monkey bike. There were a lot of parts that were needed and I started with the most obvious ones. The exhaust was hanging off and was not great so these were one of two replacements. I went for the long ones which are a universal fitment anyway. Along with some other parts in my basket, I have them all shipped together to save on some shipping costs. Not hard parts to find as they are universal anyway. Very good value for money so lets try them. ALl my order arrived in perfect condition and was received in 5 days from being shipped from Webike warehouse. The spring set came in the Kitaco box and was in tact when I got them. The springs are nothing too fancy but do have wuite a good flex and extension on them. Fitting was easy and these were perfect for my needs. Onto the next part. Thanks Webike. View detail
Genuine Kitaco Exhaust Spring Set 50mm
As I was starting a new project on a bike I have never worked on this is a bit of an experiment of mine. The bike was in a lot of bits and basically a rolling chassis with lots of boxes with parts inside. I decided to start at the smaller parts and this exhaust was never going to work right with it hanging off with zero support. I purchased both the 75mm and 50mm spring sets to be safe. Finding the parts for this bike was super easy as there are a lot of parts available and at a very good price. With some other parts in my order, I had everything shipped using EMS and my order arrived in 5 days from being shipped. The spring set arrived in perfect condition and was in a nice little Kitaco box. The springs are really small but do have some good strength behind them. Put it this way, the exhaust os now sitting as it should and not loose. Pretty impressive actually. Really enjoying this rebuild project. View detail
Cheap and just right.
[How is it used?
When I changed the Silencer of XJR400R from MotoGEARΦ100 to K2tecΦ86, the Spring used in MotoGEAR
The exhaust pipe and silencer part could not be fixed firmly because it was about 80mm long.
We measured the length and thought that around 70mm would be just right, so we purchased this product.
Was the one you received as per Image?
I didn't look at the product carefully at first and thought it would come in Silver, but it turned out to be Black.
However, it fit surprisingly well, so I do not mind using it.
How was your experience with it?
It was fixed perfectly as measured.
To be honest, Silencer won't be out without Spring, but the one that needs to be fixed.
Fix it firmly.
[Points to note]
There is nothing special about it, but if I may say so, this kind of Spring should not be overstretched.
Before purchasing this product, I purchased MORIWAKI's 65mm, but the Spring was pulled too much and was too tight. In such a case, there is a possibility that the spring may break during driving, so please be careful.
How did it compare to other products?
Anyway, I liked that the price was low.
It is named "Chamber spring" but can also be used firmly as a 4st for Silencer.
View detail
exchange
I purchased this for Spring replacement for Exhaust System installation.
The price is not that high, so it's good.
Would you have preferred it with Anti-vibration Rubber Tube? Yes, I would have.
View detail
Spring Replacement
The exhaust spring of the assembly pipe of Cb1300 (sc40) is rusty and will be replaced.
I have not installed and replaced it yet, but it looks durable. However, I think it needs to be replaced periodically because the area is easily wetted by water.
View detail