【MARUTO】New F1 Handle Cover Review
Bike riders always fight with cold. And they hesitate to have a handle cover, the cold protection item, to the very last possible moment. Now, I've reached for that forbidden fruit.[Installation]The installation is easy. All you need to do is
Bike riders always fight with cold. And they hesitate to have a handle cover, the cold protection item, to the very last possible moment. Now, I've reached for that forbidden fruit.
[Installation]
The installation is easy. All you need to do is to pierce the lever and the grip to the hole on the side of the handle cover, and then fasten it with the string attached to the mirror. You need to make sure that it is securely fastened.
* I've installed it on SUPER CUB, just below its knuckle guard. There's nothing to interfere the operation; no problem.
* In case of SUPER CUB, there is no clutch lever, as the clutch is rotary type. So it becomes a little loose compared to the accelerator side.
[Operation]
* There is no problem operating the accelerator , brake or blinker. But as the blinker of SUPER CUB is located on the right handle, it is a little hard to move the switch up and down to light it.
If you have big type of gloves like winter gloves, you will have trouble putting into that inside the handle cover. If you can put it inside, you will then not be able to move it. So you better have gloves for spring or fall.
[Wind-proof, Cold-proof]
* Temperature: 10 degrees (C). Strong Wind. I was using it along with the knuckle guard, and didn't feel the wind at all. The wind-proof effect is superb, and you can drive in the cold weather. However, it's not that warm inside the handle cover. It depends on what kind of gloves you have.
* Temperature: 2 degrees (C). It is cold inside the handle cover, but it's not the level that you can't stand. I could drive without having trouble operating the handle. But I thought at least I need to have inner gloves in case I am wearing spring/fall gloves.
[Concerns]
* I got concerned about some points, although this was my first handle cover.
(1) The raised fabric inside is too short, and its heating and heat-retaining effect isn't so good. I was expecting a more downy thing.
(2) The thumb is made transparent, and it's kind enough to make the thumb movement visible. But, you actually don't look at the switches while driving , so I doubt its necessity in the first place.
[Overview]
* Its an excellent item with wind-proof and cold-proof effect. It's cost-effective for its price. It does make sense that it s being said that it becomes the best when you use it with a grip heater. If you do not have a grip heater, you better have gloves with heating and heat-insulating effect.
Responses
Other reviews
I couldn't do this one..
After replacing the Handlebar of the CROSS CUB, I put a cover on the Right Side I followed the instruction manual and tried to put it in, but Brake lightly left it in It has become It's very dangerous if you eat the play part and start running In addition, the Brake Lock section gets in the way and it's hard to get the cover in as far as it's needed It might be a little small in the CROSS CUB I can't even return it because I made a cut to fit it The next time I have to get a large one... I think Scooter and SUPER CUB will fit in it Nah View detail
I am satisfied.
Installation of Right Handlebar finished without problem. LeftHandlebar has no Clutch or Brake lever so I was worried about fixing, but I realized that there is no problem with installation. Correct as a counter measure against cold! View detail
A hand would not be earlier taken out with what, a difference can be felt to such an extent that it says -- although the hand was numb with cold only with protection-against-the-cold glove, it came out very much and it carried out -- -- if
A hand would not be earlier taken out with what,
a difference can be felt to such an extent that it says -- although the hand was numb with cold only with
protection-against-the-cold glove, it came out very much and it carried out --
-- if it is about -3 ℃ after attaching this, since Vinyl processing is carried out, an empty hand snugly
surface.
it is being unable to use also flipping a little rain off and, as for the sushi
difficulty which was very good shopping, a draft's entering a little from a Handle part by the relation of a Mirror mounting hole being small which it passes, and cannot be come out of and attached, but has been forcibly fastened with the
string, and the
Parking brake
View detail
It equipped for the first time. Although cared only about the parenthesis until now, once it equips, you cannot win a year, and can't it remove? Although other products are not compared, they are OK with the glove for summer in commuting for 20 mi
It equipped for the first time.
Although cared only about the parenthesis until now, once it equips, you cannot win a year, and can't it remove?
Although other products are not compared, they are OK with the glove for summer in commuting for 20 minutes in the present time and the morning.
Operation is on the contrary hard to carry out the object for winter.
View detail
It attached to the dio which carried out bore up to handle cover 78cc, and saw (^u^) If it has one since it can attach easily [ a price is cheap and ] or can remove, in the appearance credit of the day of arctic cold, it is found useful. It cannot be
It attached to the dio which carried out bore up to handle cover 78cc, and saw (^u^) If it has one since it can attach easily [ a price is cheap and ] or can remove, in the appearance credit of the day of arctic cold, it is found useful.
It cannot be said that (^-^) the appearance which I regard as an effect rising further if it uses also as a grip heater since a wind is not equivalent to a hand directly is smart also in a compliment (^_^;) Since the portion of the thumb is transparent, operativity is not bad.
Since a grip and a lever cold in the cold of that to which a wind is not equivalent to a hand directly only in a handle cover are cold.
A thin glove is required... It is dangerous, if a hand does not fall out quickly when * winter glove does not have a problem in operativity, either, if a hand enters, but it falls (+o+) Since the cuff of a handle cover gets wet, a rainy day and the day with much snow.
I think that it will be hard to get dry once it gets wet (>_
View detail