【DAYTONA】Super High Throttle Kit for Mixing Review

ปะกับคันเร่ง daytona มาครบชุดพร้อมใช้งานโอเคดีครับ เลื่อนไหล ก็สมราคาอยู่ครับ ไม่แพงใครมองหาปะกับแท้ราคาไม่แพง View detail

Used for NSR50OEMcarburetor

Purchased a new High Solo with long wire when converting to bar handle.
Is the standard CR80OEM rumored to be discontinued in Mania?
Selected because I thought DAYTONA was a safe choice.

Outer wire length 870mm
Bar handle conversion is a little bit long.
I think it is a little long for OEMSeparate handle, you should choose 760mm.
In the case of NSR50, even if it is a little long, it will not cause any problem.
(In the case of Race Specification, handling problems, etc.)

Guide falls off when guide is temporarily lowered for assembly.
I looked at the Instruction Manual to check the installation orientation, but there was no picture in the Guide.
It seems a little unkind.
Solution by turning this way and that.

This time mounted on OEMcarburetor
The Outer length adjustment in two places was extended almost to the maximum Large, and the play was managed to be appropriate.
Wouldn't it be better to have a shorter inner wire? (about 10mm)
It's a Universal Product, so that might not be a problem.
Included Wire part number:29223
for RepairWire Part No. 29239
I even thought there was a packaging error here.

The degree of opening is meh High Solo lol.
May be appropriate if converted to PWKetc.
Not checked that one, I have a PWK and would like to check it eventually.
The car is still in the process of being built, so a running check has not yet been done.

With fewer and fewer options available, I'm just thankful that it's on the lineup! View detail

Very good

It may be tough in Circuit if you don't play less View detail

being on the right track

I used an XLR80 Frame with an APE 100 Engine and a carburetor with a TM-MJN24.
The XLR80 itself is NORMAL and High Solo, so I don't feel much Merit as High Solo, but I am satisfied because I can now pull off MJN24. The included Grip is a replica of the TZ Grip, which I personally prefer.
If you are replacing the throttle holder of the APE etc., you can easily feel the effect of the big cab pull-off.
This time I got it because I needed to buy a Throttle holder, but if you are planning to use it in an Off car Big cab, I think replacing the Wire is enough to give you a High Solo feeling.

It's not overly sensitive as a high solo or a big cab throttle, and I think it's just right.
If I wanted, it would be better if it were a little cheaper. View detail

A decent throttle for Fi

I bought this High Throttle for my Honda RS150 that fits perfectly. The quality of the item and the finish is great. I have to modify the item as i instaled it in a throttle body rather than the carb recommended but it still fit fine. This is cheap throttle an alternative throttle for a premium throttle. The item is package nicely. It was ship wraped in bubblewrap so item is protected. Make sure that the length of the cable is compatible witj the motorbike your going to use. View detail