【ACTIVE】Aluminum Bar End Revolver Review

Equipped with VST 250 without adjustment!

Used for DL1000 V-STROM250Custom.

I heard that it is usual to purchase and adjust washers and bolts separately for external bar ends, and I was worried about how the V-Stroke would be installed due to the combination of the Knuckle guard, but to my surprise, I was able to install it beautifully by simply replacing the body.

Bolt, Rubber, and Spacer are still from the OEM and the ones that came with them are left over.

Single Body is neither heavy nor large, so there is no vibration reduction effect, etc., but it is not worsening in any way, so it is a sufficient recommendation for the purpose of dress-up. View detail

Low price despite wide compatibility and high quality ◎

■ Design
The color and design of the Grip were chosen to match the color and design of the Grip. The large bar end is also a good choice, but since the grip installed on the bike is too flashy, we chose the compact Revolver type. I chose the compact Revolver type because the Grip is too flashy.

Performance
It is heavy for its size, but not heavy enough to suppress vibration. I think it is too small to be effective in the event of a fall. In my case, I bought it for fashion, so there is nothing more I can say about its performance.

■Difficulty of installation
This is not my experience because I asked the Shop to install it, but this product seems to be a Type that can be fixed to the Handlebar by inflating the attached RubberSpacer between the Bolt and the Handlebar. Therefore, it is good that it can be used for a wide range of car models. However, in the case of the Grom, there is an OEM Bolt hole, so it seems that the RubberSpacer can be fixed as it is without using it. However, the Throttle side is not the same size as the Spacer, and I was told that it needs to be purchased separately (in my case, the problem was solved by diverting the surplus parts that were generated when replacing the Bar End of the PCX that I had requested together).
Also, in the case of JC75 Grom, it seems that the OEM Bar End is so tightened by the devil's Torque that the Screw Mounts are screwed up, and when removing it, it has to be forcibly removed using a Spanner. Therefore, if you want to keep the OEM bar end on your Beauty, you will have to go through a lot of trouble.

*Please note that the photos include the Grip that was installed at the same time. View detail

It is overpriced.

I purchased this product to replace a handlebar.
There are several types of Size, but Grom
This Size is a Just fit for
It seems as if View detail

For the price

The texture, precision, and color of the product were good, and the Large change was satisfactory. View detail

Bar End.

I use it on my ZrX1200R.
I bought it because I wanted the Handlebar area to be Black.
I like the way it looks. Installation is easy as well, just insert and tighten.
I also have Blue, which I swap out every once in a while for a change of pace. View detail