【TANAX】Multi Mount A MF-4676 Review
It was smaller than I expected
Used for installation of external water temperature gauge.
Size of Mount is vertical : 20 mm width : Small than I expected to be 40 mm, I felt unsatisfactory compared to the Size of the water temperature gauge.
I felt squeezing the installation in the bar, but the entrance was too narrow and did not enter inside. Bolt and Nut were also Small, and it was a bit inconvenient Size to tighten.
In order to install the water temperature gauge, I think that it is removable by Magic tape considering serviceability.
Responses
Other reviews
I used it to install a voltmeter!
It was used to install a Ditona voltmeter on a Multi Bar.
Just fit! I think it's a Level that can be called an exclusive product!
A little expensive for a small?" I thought at the time of purchase that the quality was high, but no problem!
Very Recommendation!!!!
View detail
Used to fix voltmeters
It is inexpensive compared to other products. It can be installed anywhere.
It is a good item
View detail
On the REMOTE CONTROLLERBracket of the Drrorecorder
I use it as a Bracket for my Mistuba Sankoit EDR-21 REMOTE CONTROLLER. The size of the bracket is very small and the handlebar is not too tight. View detail
As a mounting bracket for DAYTONA voltmeter
Very happy with the ability to set any angle View detail
On the clock tower
Oil Temperature Gauge's watch was attached until now, but Spec. Changes make the clock run out
I used this Bracket to attach another watch.
It is reasonable from the price
View detail