【NA Metal Craft】Brake Torque Rod Review
Clean cutting products.
Steel's Torque rod of OEM tried to replace because the paint was scratched and dirty due to rust. I am happy because it is lighter than the OEM because it has a beautiful cutting process and the finish of Anodized is glossy. By the way, in my case, when I installed it properly, the Rubber cover covering the previous Bolt interfered with the Exhaust System and it seemed to melt so I attached it to the reverse side.
I hope the price is a little cheaper but I guess there is no way to consider processing Cost.
Responses
Other reviews
Processing Required
Is this incompatible with Active's Rear caliper support?
I had to use Grinderetc. to cut off the radius to install it.
View detail
na metal craft torque rod
pure quality , perfect fit and sits nice next to the gold caliper , very high quality , and will never rust great , brembo calipers are next on the bucket list , then ohlin rears View detail
A bit lighter
I replaced the NORMAL steel Torque rod with this one to reduce weight and appearance. It is light because it is made of Duralumin compared with NORMAL which I removed. Because it interferes with the Wheel when pulling out the Bolt of the front side to the inside, it was troublesome because it was necessary to loosen the Excessen and move the Wheel to the front, but the texture is good and I am satisfied. View detail
For appearance
It is a Parts whose performance does not quite understand to an amateur like me.
Making is well done and may look good as one point.
View detail