【DAYTONA】Stainless Pad Tweezers Review
Fits: KAWASAKI 1R, KAWASAKI GPZ900R, KAWASAKI KR-1S, KAWASAKI ZRX1100, KAWASAKI ZRX1100, KAWASAKI ZRX1100 2, KAWASAKI ZRX1100 2, KAWASAKI ZRX1200DAEG, KAWASAKI ZRX1200R, KAWASAKI ZRX1200R, KAWASAKI ZRX1200S, KAWASAKI ZRX1200S, KAWASAKI ZRX400, KAWASAKI ZRX400, KAWASAKI ZRX400 2, KAWASAKI ZRX400 2, KAWASAKI ZX-12R, KAWASAKI ZX-12R, KAWASAKI ZX-12R, KAWASAKI ZX-12R,
Instead of rusting OEM
【What made you decide the purchase?】
OEM's Pad pin was rusty
【How was it actually used?】
Stainless So it will not rust ??
【Mounting was difficult?】
Just replace with OEM
【Please tell me the installation point and hang】
None
[Is there anything I was disappointed about?]
A bit expensive - - -
【Hope for Manufacturer - Please let me know if you have any improvement points]
Nothing in particular
【Have you compared items?】
OEM
[Others]
Nothing in particular
Responses
Other reviews
Maintenance.
I have not used it yet but the Bolt on the R1 has rusted so I bought it to replace it.
I would recommend everyone to replace it before this happens because it will make the Brake less effective. LOL!
View detail
I replace them regularly.
This is a small component, but it is a large component that holds Brake Pads.
Rust-resistant Stainless Steel is easy to maintain.
View detail
Just received them
I just received my package. Everything is well packed,thank you. Tha brake pad pins looks very nice and high quality. When i install them in a few days i will write more View detail
Is there a problem with being thinner than OEM?
I'm sorry I couldn't provide a photo, but when I used it on my NINJA2 Helmet 50RSL, I compared it with the OEM one, and the shaft part that holds the pad is clearly thinner,
The measurements were taken from the OEM, so they should be the same diameter." This was the case
I have a question for those who are familiar with Brake, is there any particular problem with the thin shaft part?
Has anyone who bought the same Stainless Steel Pad Pin had a similar case? I would like to hear your opinion. Thank you in advance.
View detail
More rust-resistant than OEM Product
I used this for an overhaul of a very old OEM Caliper. The previous owner had maintained it to some extent and it was not so badly worn, but I wanted to assemble it in a new and clean condition if I was going to overhaul it. I chose it because I wanted to assemble it in a brand new and clean condition. View detail