【MINIMOTO】Chain Tool #420,428,520,525 and 530 Review
It can break immediately with the first time
There was a set of Body and a substitute Pick.
First turn turn Screw before Chain cut and you see that Pick is bent.
Since I can not use it, I tried doing it with Cut, but it caught on pulling out and broke.
When I exchanged for a replacement Pick and turned Screw, it was not bent more than the first one.
Chain cut and tried to pull out again.
It is durable due to poor precision.
If so high things are better.
Responses
Other reviews
cheap
It is not a high-end product, so this is sufficient unless you use it to do everything.
If you can't seem to get the Pin out when you pull it out.
You can use it after shaving it with a grinder and it is up to you to devise a way to use it.
It is useful if you have it.
View detail
Part accuracy and durability are bad
It is typical of bad mood.
Whatever versatility is not to choose Size
Part accuracy is too bad and there is no durability.
didNon-seal (The cheapest one)
I used it to cut 525 Size.
The core is slightly bent from the beginning, it is difficult to capture the center
Furthermore, when extruding Pin, the tool side loses
The core cracked vertically, it got broken.
Although it responded with the attached spare parts,
Although it endured work,
I crooked again and I can not use it anymore.
It's almost disposable.
There is no complaint because the price is price ,,,
Conversely I was impressed with the durability of Did.
Parts pushing out the core (?) As
Small Sana Bearing has 1 pcs..
It is a part not included in Instruction Manual,
When exchanging the core, if you disassemble it inadvertently
Be careful as it will definitely lose it.
I do not know what will happen if it's gone.
View detail
Chain exchange is done
I bought it by changing my own Chain.
The texture is not good but there was no problem with the motion.
Moreover, it can be used not only to remove Pin but also for press-fitting Plate after changing Chain
So that is a good tool for that point.
View detail
To Chainfor Replacement
I've been Cut in Grinder so far but it takes time and it is troublesome so I bought it with Chain this time. The Chain Tool that I was planning to purchase was out of stock so I made it the cheapest kore. When opening for the first time I saw it was somewhat uneasy because I was not able to see things that seemed to be of good quality in flattery even though I was worth seeing at the first time. But Chain's Cut was okay as it made it without problems.
However, is the accuracy of the core pushing out Pin poor? It is Large strange to remove from Chain after Cut. I knew that it would be okay if I used it only once a year because it was missing if it was lightly touched with a slotted screwdriver.
If you do not use it frequently in business etc. I think that it is Recommendation.
View detail