【TANAX】Magres 380 Quick Review
Reliable on expressway
We are installed in resin Tank Cover of Honda CBR 1000 RR.
You can use it on a highway without problems. I am using iPhone 6S, but the capacity is more than necessary enough. Small It is thought that we can still enter the change.
Size is just right, too much deck put on Tank makes it difficult to drive, so it's just a good sense of size.
Male control type Steering Damper, HESD equipped Motorcycle Due to the margin of Top Bridge. However, if you use this, it is enough for a portable Holder. If you open the Fastener a little, you can also insert a charging cable inside.
Responses
Other reviews
Movable flap with sucking disc to secure the well
Purchased for my phone.
The good thing about the Suction Cup
My motorcycle is a steel plating tank, so I was looking for a suction cup type because of the risk of damage with a magnet.
The suction cup at the bottom of the center of the bag is not usable because it is attached to the tank belt, and it is unnecessary.
And the Flap of Both Sides was Firmly and strongly attached with the two Suction Cups (standard position) in parallel with the Tank belt.
Less Risk of Wound worn in Suction Cup
Suction Cup position can be freely moved for easy installation
Suction Cup Repair Parts from TANAX are readily available even if the cup deteriorates.
● The feel is fine if you only use the phone.
The latest large smartphones can also afford it, [Color] Touch screen from the clear surface is also available, but it is difficult to operate in detail.
Also, if the phone is covered with a Glass-type protective Seat, the Touch response will be poor.
Bag can be mounted either horizontally or vertically
Easy to attach and detach the bag with just a hinel.
When placing it horizontally, the handlebar should be placed a little to the rear because it will hit the bag if the handlebar is fully extended.
When I installed the bag vertically, the handlebar did not interfere with the bag when the center of the bag was placed over the fueling port.
In any case, you have to lower your eyes to look at the smartphone screen while navigating, so you have to be careful when moving forward.
Smartphone holders can cause camera failure due to direct vibration to the smartphone, but this backer suppresses vibration, so there is less risk of failure.
I think the smartphone thermal runaway Risk will be higher in the summer, so please be careful!
View detail
Hard to light with tank shape
yzf-r25 (19 years old) The shape of the tank is complicated, so you need to be creative to attach it. I think that it is quite troublesome to take off and to put on Suction Cup, so I cannot recommend it to the person who is thinking of such a use. View detail
Hmm!
Placed - - The screen can not be seen! The angle of attachment does not match.
Besides - - It is a terrible fever! It is a destiny of this type.
It can not be helped. Let's use it as Accessory Case.
View detail
You can customize the position of Suction Cup.
In the Z1000, Tank is excited and in the Standard place
Although it could not be installed, Suction Cup of MOTOFIZZOption had many common items, it was able to install Flap with sucking disc and Suction Cup from the original Tank Bag and put it in the best position. (You can also purchase)
Safety Strap is short, it is -1 because it was not attached to Motorcycle.
View detail