【KIJIMA】ACC Branch Harness Review

DL1000 V-STROM800 used for power extraction under Seat

The DL1000 V-STROM800 has an OEMOption to install a 12VCigar lighter socket under the Rear Sets. The Attachment power supply Wiring for this purpose comes to the position shown in the photo. If you use KIJIMA's ACC Branch Harness that you purchased, you can get the power supply in Couplet-on. However, please note that the +- terminals are reversed, so the terminals need to be replaced. This is recommended for those who do not want to damage the existing Wiring. View detail

Plus minus needs to be replaced in reverse for GSX1300R HAYABUSA

Precision Driver is required to shift the rubber packing→push down the gold part→replace the Plus minus→and restore the current state. View detail

To the third generation hayabusa!

Can be installed on the ACC Power Connector under the Tandem seat of the 3rd generation hayabusa.
However, the + and − are reversed, so they need to be replaced. If you know how to do this, it's not a big deal, but if you don't know how to do it, it may be difficult the first time you do it unless you have someone who knows how to do it teach you. View detail

Easy connection.

It is easy to install because it only needs to be branched from the Position lamp.
Because Size of Bullet Type Terminal is thin, there is anxiety about the connection, but it is normal at present. View detail

Small processing is required when installing on New ModelHAYABUSA.

[How is it used?
I purchased it for USB Power Port installation of New ModelHAYABUSA.
This is for the GSX-S1000, but the Coupler is the same shape, so it can be used.

Was the one you received as per Image?
The product is as shown in the picture.

How was your experience with it?
The Coupler can be installed as is, so the job is done quickly.

[Points to note]
Because New ModelHAYABUSA is special or the + and - are reversed, it is necessary to replace the terminal before installation.
Precision Driver or mechanical pencil is fine, so you can replace it by just pushing inside the Pin a little.

How did it compare to other products?
There is no particular comparison.

Other items that would be helpful
Point and hang of installation
As I said in the points to note, the + and - are reversed, so just be careful there.
I was able to install the UniversalConnector without any difficulty.

[ITEMS TO BUY TOGETHER
The list which I purchased for installation this time

KIJIMA KIJIMA:304-7150
ACC Branch Harness
https://www.webike.net/sd/22895068/

DAYTONA DAYTONA:98830
Attachment Power Supply Unit D-UNIT (D-Unit)
https://www.webike.net/sd/24050519/

DAYTONA DAYTONA:95444
Mount Kit Multi Bar Holder
https://www.webike.net/sd/23315099/

DAYTONA DAYTONA:92750
Multi Bar Holder Stem Hole Clamp Short Low Type
https://www.webike.net/sd/21846547/ View detail