【P&A International】Extender Fender Review
Fits: HONDA NC750X, HONDA NC750S, HONDA NC700X, HONDA NC700S
The price is a little too high
Basically, I don't ride on a rainy day, but when I passed the place where water is being sprayed by construction, it was a horrible accident So I installed it
The intuition with the Fender was perfect, but the treatment of the end surface is quite rough Because the double-sided tape which comes with is too shabby, it is not possible to use the Nitto No. which I have on hand I replaced it with 577
I've noticed that many people seem to be installing it with just Double-sided Tape I also used the 2 included pins to prevent the situation where they were missing (4 Pin is attached.) It may be that Double-sided Tape was a thick type, but The pins were not long enough to stop properly, so I welded them together with a soldering iron
I haven't run in the water yet, but the effect is quite promising based on the position of the Tire That's right
I think the price is a bit too high, including the detail work
Responses
Other reviews
I'm satisfied.
I was able to install it. How does it feel on a rainy day?
Also, to be honest, I didn't want to drill the holes with Drill, so I stuck it on at first with the adhesive tape that came with it, but still. Do you like the design or something?
View detail
Extended OEM Front Fender length
Water and mud splashes are reduced and feet are less likely to get wet.
After driving on a forest road, mud was accumulating and hardening near the cooling fan. After installation, the mud splashing was reduced and the mud no longer splashed onto the cooling fan.
Double-sided Tape and Clip for mounting in quantity:It comes as a set. I drilled a hole in the Fender and installed the Clip only, without double-sided tape for easy removal.
View detail
Note the placement of the double-sided tape.
Dirt comes up to the Radiator and Stem, so it is installed.
It is more troublesome than expected because it is necessary to remove the Wheel to remove the Fender.
It fits perfectly without Tape, so if Tape is applied to the sides, it will not go all the way in due to the thickness and adhesiveness of the Tape.
So, I only put it on the front part, but it can be fixed quite firmly.
However, since the motorcycle runs 300km, the included Rivet must be used and a 4mm hole must be drilled just in case.
The black color on the green-light Fender is almost conspicuous, but since it is located in the back of the house, it is hardly noticeable.
I have used it on other cars and the spray stops around the bottom of the Radiator, which makes washing the car easier.
View detail
Mudguard on bmw r1200r
Installation is a simple process of attaching with the included double-sided tape.
Effectiveness.
Small stones and mud rolled up by Front are reduced.
If only it were a little longer? 5.
View detail
FenderExtender on the grom
I purchased these to reduce mud splatter on my Horizontal TypeEngine when I bought my Grom new. I used 3M double-sided tape instead of the supplied double-sided tape for installation. It has been 7 years and 56,000km since I bought it and it has reduced the mud splatter without any deterioration. I thought that the cost performance might not be so good, but I have not had any problems for more than 50,000 km, so I felt again that it is a good product. View detail