【CF POSH】Aluminum Cut-out Baffle for Silencer Review

For vehicle inspection.

It is good because it is inexpensive, and I think it is easy to process because it is made of aluminum. View detail

Performance as a Baffle

Looks and finishes are good.
I've gone to the trouble of installing it.
There was almost no change in volume as Baffle. View detail

DF200 DJEBEL Used at Rough & Road RSVSilencer

I purchased a used RSVSilencer and installed it because it was too annoying.
BoltQuantity for installation:They said 2 pcs, but we decided to TRY with 1 pc.
The rear end of the Silencer is gradually enlarged from 3, 4.5, to 6.5mm to allow the attached M6 bolt to penetrate.
"Okay" and put it against the Silencer exit... I can't get in!"

Caliper's actual measurement was 47mm, so I bought 47mm, but 46mm seemed to be the right choice.
I inserted it by tapping it as hard as I could with the wooden handle of the plastic handles.

After the installation, the exhaust sound was very loud. Slightly more energetic NORMAL?" Ranked first.
When Idling "Chica Chica." and the Tappet sound is so good that it sounds like a HUDDRILL. This is good.
I immediately performed a test run and did not feel any extreme power down, even when I turned it as hard as I could.
Also, totally unexpectedly, the low-speed Torque was enriched.

I am satisfied with the Large change because it is quieter and easier to ride.
I found this in someone else's Review, but the Hexagonal Wrench was not attached. View detail

Aluminum is dirtier and less rusty

Material:I chose this one because it is aluminum and seems to be rustproof.

It is not cheap, and the precision is perfect. View detail

It'll be quieter than you think.

I installed it on my KSR110 Nassat RR with an external exhaust system, and even though it is a JMCA Certified exhaust system, I bought it to avoid disturbing my neighbors because of the heavy bass sound. It is quieter than I expected. I don't think I'll have any complaints about this. View detail