【K-FACTORY】Front Axle Slider Review

countermeasure against standing up

Coloring also matched Cafe in Black??Gold.
We won't know the effect until we take it down, but installing it as an insurance policy gave us great peace of mind. View detail

Risk Reduction

[How is it used?
In case of emergency.

Was the installation difficult?
Remove the NORMAL AxleBolt→attach the included AxleBolt (with a hole for the shaft)→Slideretc. and attach the rest of the parts. If you have a Glasses Wrench and a Hexagonal Wrench, all you need to do is to follow the instruction manual. It took me about 10 minutes to do it.

How was your experience with it?
If you look closely, there is a small gap between the brake side bolt and the gold base plate, which is not a good parenthesis.
But overall, I am satisfied with the Dress-up and everything else.
I'm glad I put it on." I hope that the day will never come when we will be able to do so. View detail

k-factory stuff was always good

The left and right sliders are very light and neatly injected. It's simple to install it by putting it in the left and right holes of the front axle. I have z900rs, but I changed the front suspension to raise up light I bought it for cb1300sb and installed it. The middle gold metal ring has a very good design. View detail

No worries in case you fall down!

[How is it used?
I purchased this car so that I can drive it safely even if I fall down when I go on a long trip, such as touring destinations.

Was the one you received as per Image?
Quality is as good as the Image.
The precision of the screws and pipe lengths, etc., were fine.

Was the installation difficult?
It was a complete Bolt On.
I was concerned about the durability of the Axle ShaftBolt since it is a hole type, but when I saw the product, I was reassured that it was well made.

How was your experience with it?
I have not fallen down yet, but it also has a dress-up effect.

[Included Parts:were they on?
Instruction Manual, Bolt, Shaftetc.

[Was there anything that disappointed you?
I am concerned about the durability as it is anodized and may fade in the future due to sunburn, etc.

For Honda models other than CB1100, CB400SF, CB1300, etc.Fork pitch is the same type and can be used with Hollow Axle Shaft by Bolt On. In my case, I use it with 0 pointsShaft and it works fine. View detail

Emphasis on decoration

It was the first product that came out, so I installed it, but it is a little expensive. I was glad that there were no decorative elements in this part, such as the decorative plate on the base or the aluminum collar, which is not visible after installation.
Quantity:Pair (for Left and Right) Note that two sockets of the same size are required because they will be supplied if they are not held from the
I don't know how effective it is because I haven't tipped it over. (I feel that if the bottom case is tipped over in such a way that it is damaged, it would not be enough to protect Axle.)

I think it would be easier to attach and detach if one side is fixed, but I don't know why.:Pair (for Left and Right) It is a hassle because you have to hold it down from the View detail