【MINIMOTO】Super Light Front Sprocket Review
Fits: HONDA XR100MOTARD, HONDA XR50 MOTARD, HONDA NSR80, HONDA NSR50, HONDA SUPER CUB 90, HONDA SUPER CUB70, HONDA SUPER CUB 50, HONDA APE 100, HONDA APE 50, HONDA DAX, HONDA GORILLA, HONDA MONKEY, HONDA glom
No complaints with an investment of just over $1,000
Installed on the 2019 AA09 SUPER CUB 50
My complaint about the CUB is that it's too low GEARd for some reason The first Driven Sprocket has a 13T, I converted it to a 15T It is as large as you can get
The aim of the conversion
It's a quick, low cost way to get rid of frustration
After conversion
1st gear is now available 。 Before the conversion, the engine roared in 1st gear and the speed was not as fast as it should have been It was
So, it was always second gear 。 If I wanted to, I'd like to pull more and connect it to second gear, but it's 50cc, so that would be a compromise
The connection of each GEAR becomes Smooth, and it is pulled by each GEAR, and at the end it is connected to the Top It was able to pull enough on the flat terrain
In a headwind or on an uphill slope, I'd like to downshift the car, but I'm not sure if the top speed will be as high as it should be It's a Large Merit
In other words, it means that you can ride in the city and in the flow of traffic, which means that you can drive safely (see (The CUB couldn't get into the flow of the city because of the lack of speed)
Installation notes
There is a U-shaped Sprocket guard inside the Sprocket Cover, after the conversion As it is, this Sprocket guard and the Chain will interfere with each other, so the
The Sprocket Cover won't close, and it looks like you all have a lot going on the..
T=about 2mm of resin Washer is inserted in place of the Sprocket guard I made the Sprocket Cover close. 2 Washer with Red Arrow
General review
For an investment of a little over $1,000, you can ride with a good feeling, so you can't complain
Responses
Other reviews
Sprocket
Sprocket, one of Motorcycle's smallest cogs. View detail
Fixing plate defective
Fixing plate could not be installed and we had to use the previous Plate.
If you want to purchase this, you normally recommend KITACO.
View detail
I bought this with the intention of using it with nsr80 but…
The groove of the fixing plate is too large to rotate, so I could not install it.
I wonder if it can be installed on a MONKEY engine.
View detail
Normal good
I think it's good that it has Bolt and Plate, and I think the Bolt is Hexagon Socket to avoid interference with the Shaft. View detail
I used it on Grom!
I installed it on my Honda Grom, which is active in commuting and touring in Large. To be honest, I don't know how it feels to have changed it, but I feel better now that it's new. I hope it will last for a long time. View detail