【K-PIT】Exhaust Gasket Review
Fits: KAWASAKI Z1000 MARK II All models, KAWASAKI 750RS(Z2) All models, KAWASAKI ELIMINATOR 250V *RExhaust pipe middle joint part All VN250A models, KAWASAKI ZXR750 ZX750H All models, KAWASAKI GPX750R All models, KAWASAKI Z1, KAWASAKI Z1000J All models, KAWASAKI Z1000R All models
good
Replaced at the time of Exhaust System replacement
Because the exhaust stud bolts on the 750RS are M6, the exhaust stud bolts are reused with the crushed gasket Too much tightening will cause the Bolt to break easily
Replacing the gasket when replacing the Exhaust System is a great way to reduce the risk of bolt breakage I think it's to reduce
Replacing these consumables rapidly is a Large thing
Responses
Other reviews
Very common EXGaskett
CROSSCUB110 (JA45) Used to replace the Exhaust System of
I think Gasket is the same for all Manufacturers.
No exhaust leak etc.
It was cheaper than OEM Parts.
View detail
Purchased for PowerBox installation
Purchased for PowerBox installation.
One piece is all that is needed.
I had a hard time removing the old Gasket.
The new one, after applying liquid Gasket.
If it is attached, it will not come off.
View detail
Exhaust Gasket
It can be used without any problem in Material and Size. View detail
Exhaust gasket identical to the original
About quality and texture The exhaust ring-gasket is of the highest quality, made completely identical to the original, the same texture, dimensions and materials, however, a little cheaper and from a trusted consumables company About the feeling of use Excellent compatibility with the original cylinder, which once again proves the high quality, the ring is strong and at the same time soft, which allows you to achieve a perfect fit of the two flanges and the best possible seal to prevent exhaust gases from breaking past the muffler. After installing this ring, there is not a single drop of oil leaks on the exhaust flange of the cylinder, as well as any fogging Products to buy together An independent product, no additional purchases required Difficulty of installation Easy installation to replace the old O-ring, fits perfectly into place, does not fall out, but is not difficult to install, perfect fit Cost performance and comparison with other products Low cost, high quality, one of best replacements for the original on the market About shipping and packaging Packaged in a simple small package, no damage in delivery, very compact product Any concerns, cautions, or advice when purchasing Just make sure the product is fully compatible with your vehicle View detail
Exhaust System Replacement
Purchased because I replaced front pipe with Other Brand Product!
Compared to OEM Product, the price is about twice as much.
K-PIT is sufficient since it is consumable.
View detail