【PINGEL】Plate for 1/4NPT Fuel Cock Adapter Review
Accuracy and texture are good.
I used it for PinGelCook installation. The texture accuracy is very good.
It's easy to install and can be done by anyone, and it's the perfect companion for your fcr.
Responses
Other reviews
PinGelPlate
It is essential to install PinGelCook. View detail
ได้รับแล้วนะครับ ถูกต้องครบถ้วนตรงตามที่สั่ง สินค้า ดีและมีคุณภาพ คุ้มค่าคุ้มราคาครับผม การให้บริการ จากร้านค้าดี โอกาสหน้าจะมาซื้ออีกครับ View detail
You're early!
PinGel's Fuel Cock and Quantity:I bought it in a Set, but it was a fast response, and Motorcycle became Parenthesis well. View detail
To divert the tank of a SEA BASS car
I used it to divert the tank of DRZ400 to DR250R of SEA BASS
I managed to avoid the interference with the Frame and Engine hanger on the back of the tank by beating it I did, but there was nothing I could do about Fuel Cock
Both DRZ's and DR's come too far down and interfere with the cylinder head or cylinder I will
This is where I came up with the PinGelCookAdapter
It was originally intended to be used for Kawasaki's ZrX1100/1200, ZEPHYR, etc The Pitch for PinGelCook is the same as the Adapter for PinGelCook This is a miracle that happened
Of course the bolt diameter is the same, so you can put it on as it is
Originally I would have installed a 1/4 NPTPinGelCook here, but my budget is limited and There are, therefore, Harley-Davidson and others sold by Guts Chrome I used a Brass petcock like the one used on the Custom car
The mounting diameter is the same 1/4 NPT, so it comes standard
I wrapped a seal tape around it just to be sure, but it doesn't bleed gasoline It was
This Brass petcock is very small, so it helps to avoid interference even more They gave me
No one will do this, but you can use it this way
If you are not satisfied with the flow rate of the DRZ, you may want to consider using High flowCook is easy to do
High Camshaft&FCR Carburetor Body I've never heard of putting Carburetor in and spinning it around, but I've never heard of it being enough & hellip; lol
View detail
This is cheaper to buy!
It's a Birdie, but I use it to mount the Powko Cook from FOR HARLEY
It is also possible to use a different Offset to interfere with the Carburetor and Cook It is also beneficial for avoidance
The Tap is a bit special, so it's a bit sluggish to make it yourself …
View detail