【JILLS】Side Mirror Clamp Review
If you just want to use it, this will do the trick!
You may want to relocate Mirror quite a bit and use it, right?
With OEMs, it's often attached to the switch box or rebar clamp, and this is handy when you want to get it out of the way.
This type of product is available at PinDrill, but if you just want to relocate it, this is good enough for you.
Responses
Other reviews
The attached Bolt ,,,
The included Bolt was easily torn off during tightening.
Let's pay attention to Torque at tightening.
Other than that I think that it is an excellent product for Cost performance.
View detail
Mirror installation of KSR 110PRO
The acquaintance attached Mirror under Handlebar is often Parenthesis, purchase, part cut part is obviously wanted to imitate, but impression that there is no part that cuts hands such as BALI and it is not bad despite price was.
After actually installing it, I closed the Screw in the place where the Handlebar was bent, and it cracked quite easily. My mistake I did not put on the straight side of Pipe.
I finally got it like the picture below. The degree of freedom of installation is high, I think that not only Mirror but also various ways of using it are cheap.
View detail
Cheap to use
【What made you decide the purchase?】 Low price
【How was it actually used?】 good. Useable. Simple.
[Is there anything I was disappointed about?] At the time of temporary fastening, the attached Bolt could not tighten the hand. It was a work at a time but I felt uncomfortable.
【Hope for Manufacturer - Please tell me if there are any improvement points?】 Improvement of Bolt, Tap.
【Have you compared items?】 None
[Others] It attached to KDX 125 SR purchased in second hand.
Mirror used what I had in home Garage.
View detail