【K-CON】Spacer Nut (Stainless Steel) Review

In Repair.

Installation was easy and problem free! View detail

Inexpensive but very effective Large

The rattle of SR400's clutch lever has become very bad, and it shakes when idling. I left it alone, but then I found out about KITACO Spacer Washer and bought it.:1pc.0.3mm thin, Quantity at top and bottom:I put in 1 pc. at a time. The rattles are gone. But you have to have enough clearance to put two pieces in. In that case, you need to use Quantity:Only 1pc. is also available. There are 0.3 and 0.5mm thicknesses and several diameters. View detail

Even if there is a large rattle, the gap is much smaller than you think.

I bought the 0.3mm Clutch lever as a repair for the Clutch lever that had become completely rickety after years of use.
The Clutch Lever pivot is always diminishing, and even if you replace the lever, the lever will not rattle as much as you think if the lever holder is worn out, but just adding this Shim will solve the problem!

So, it's not so easy to make recommendations to everyone.
That's because even the thinnest 0.3mm would normally be difficult to insert.

I used 0.3mm at the Lever tip with nearly 20mm of up and down wobble, but even with such a loud wobble, 0.3mm is Limit.
Quantity 0.3mm on top and bottom of Lever pivot before purchase:I was going to insert 1pc. at a time, but it was impossible to insert 2pcs.
In the end, it was all I could do to put one in the bottom side of the lever, which would be the easiest to reduce.

However, if Quantity:With just 1pc. of the new product, the Lever's rattle has been dramatically improved, resulting in smooth Lever operation and no rattling, just like new.
This is not a solution for everything, but it is a recommendation for those who cannot get rid of the rattle even after replacing the lever (i.e., the lever holder is decreasing).

If I had the time, I would dare to cut down the LeverBody from the new car and put a Washer above and below each Pivot.
This way, the Lever Body's aluminum and Lever Holder's aluminum won't come in contact with each other, and the Lever Feel can be maintained for a long time if it's well greased up. View detail

I think a little more Size would be nice.

I bought 0.3mm thick with 10mm inner diameter to improve the rattling of Chinese Lever.
The result was slightly too thick to use.
I wish there was a thinner 0.1-0.2mm View detail

To adjust K-PITLever

I bought it to adjust the wobble of the K-PITLever.
As a result, there were few gaps and no need for installation.
The price is so low that you should buy a body that needs to be adjusted.
I will keep it in case I need it someday. View detail