【AS Uotani】SPII Plug Cord Set (for 4 Plug) Review

AS Uotani SP?Plug Cord Set (for 4Plug)

It's been about 10 years since I installed SPII on my CB750FB. this is the second time I replaced the plug cord. idling and engine starting became unstable, so I replaced it after 5 years.
The terminals are pre-plugged into the plug cord and the quantity:Waterproof Cover can also be attached smoothly to the Plug cord and Waterproof Cover by spraying Silicon Spray.
After the replacement, the engine started smoothly and idling was stable without any change in Carburetor settings.
Carburetor is CR29 + M Nozzle, ignition system is MSA + V-UP16.
In order to eliminate the anxiety of long touring in older vehicles, we believe it is safe to replace consumable parts that are of concern as soon as possible.
It's not cheap, but it's a good thing to be prepared, so you can enjoy your motorcycle with peace of mind this season. View detail

Crimp-prepared, easy and reliable.

Used to install the Uotani Full powerKit.
Due to the characteristics of the car, a long cord was needed to change the handling to a large cord.
At first, I tried to crimp the terminals with my Electric Works Pliers using a different cord, but the size of the terminals was too large to crimp properly, leaving me a little uneasy.
This product is pre-crimped with a special tool from the beginning.

One complaint I would raise is the hardness of the 1234 marker.
I understand that it is a bad idea to remove it easily, but it was so hard that I gave up on attaching it.
It was no help either, but the Plug cordCover of the Uotani Body was also very stiff and the installation was Large strange.
Combined with that, I gave up because my finger power had reached its limit (laughs).

The Plug cord itself is satisfactory. View detail