• Home
  • Product reviews
  • Motorcycle Parts
  • Exhausts
  • Full Exhaust System
  • Setting after Exhaust System installation... (KENTEC: Low-rider 2in1 Exhaust Φ90)
steps-review.png

【KENTEC】Low-rider 2in1 Exhaust Φ90 Review
Low-rider 2in1 Exhaust Φ90 KENTEC
KENTEC
Low-rider 2in1 Exhaust Φ90

Fits: HONDA SHADOW400

Japanese Webike user Japan
4/5

Setting after Exhaust System installation

The installation of the Exhaust System was done by two people and it took less than 30 minutes.
The sound is more powerful and it looks better.
The exhaust system of shadow400 is thick and good for parenthesis, but the sound was too quiet, so I changed it and I am satisfied.

Since you have to use a Normal muffler Bracket
When you remove the Normal muffler, it is convenient to remove the Bracket.

I changed the exhaust system and started to drive with the air cleaner set to NORMAL, but the setting shifted and the Axel did not blow after the middle opening.
It was noticeably sluggish, so I did a carburetor Setting.
I just finished setting up the Carburetor and it looks really good with the Torque look.

------------------------------------
Current Carburetor setting
102 Main jet on Front
112 Main jet on Rear
------------------------------------
There is a little Gasoline smell when AxelOff.
It may be a little dense.
If you want to ride with this setting, you need to increase the air volume.
I'm considering modifying the Air cleanerBox or adding an external Filter or something.
------------------------------------
The proper place for Main jet is
I'm thinking about Front100Rear108 for the summer.
I have the 100 and 110 Main jets, so I'll ride them for a while, see what the Plug is like, and decide.
------------------------------------
Main jet is KEIHIN Maru Large.
Main jet 7mm wrench is needed to remove it.
It would be better to have several slotted screwdrivers of different thicknesses to avoid damaging the main jet.
------------------------------------
Removing the Air cleanerBox or carburetor and replacing the Jet is a three hour job for an experienced person, so it's worth a try.
Many of the screws around the carburetor are soft, so you will need a tool that fits the screw hole.
Those who do so do so at their own risk.
------------------------------------
The diameter of the air cleaner duct carburetor mounting is approximately 50mm
If you want to add a Power Filter or something similar, you will need its Size.

Show origin

Responses