【RADICAL】Chromoly Axle Shaft Review

well

Following the Front
Rear was also replaced.
NORMAL605g
Chromoly420g
I look forward to a test run later in the day! View detail

I thought it was just a stick.

I put it on a ZEPHYR750 with GALE SPEED wheel.
First of all, I felt the lightness when I straddled it and backed it out of Garage.
Next, Curve driving
I think it is because my Motorcycle has been converted to 18Inch.
It was the kind of Motorcycle that Curve would not turn!
Of course, if you shift your buttocks in a Large gesture, it will bend.
I was a little frustrated.
I changed to this product and ran it.
Curve has become curved and
The test let go of the Curve before the test and
When the Curve is bent, the Handlebar is also bent naturally.
It was a very good Fee Ring.
And it's very light compared to OEMWheel.
Wheel feels very light in the front.
It was too good to be feeRing.
I'm even ordering for Rear!
Maybe it's because Machine is old and I feel like it's too much. View detail

Chromoly Axle Shaft

I installed it on my ZEPHYR750, and to be honest, I was skeptical about it, but as soon as I installed it, I could see the difference. The stability is much different, and I can feel it is stable even on undulating road surfaces. View detail

person who does the work behind the scenes

I bought it based on other people's impressions. I was quite resistant before I purchased it, and haDrill to say, this price for one stick! View detail

so-so

I wanted to try ChromolyShaft because of its reputation and bought it with half a doubt. Unfortunately, I don't feel any lighter when I handle it. After installing the ChromolyShaft, I drove around the neighborhood and I can feel that the front is firm and the snap is firm. Certainly, there is a sense of firmness in the brake as well. It may be necessary to set the Fork as it also picks up the road surface condition. I think straight line stability has improved. The installation will require a 30Socket or Glasses Wrench as the Bolt will be installed through the OEM hex hole. The Fork was leveled before installation. Straight line stability is improved because of the leveling. As a side note, the service manual for the ZX12R states to jack-up the Oil FilterBase when raising the Front, but it is very unstable. Use a solid tool. Also, I have installed Babyface's Slider on the front, but since the shaft is now a bolt type, the Slider sticks out strangely to the right. It is not a problem in terms of functionality, but it is somehow not cool. Also, the surface treatment of the shaft is weak, and it peels off just by attaching it with a socket, which is unfortunate. The instruction manual is not very good. The instruction manual is not good, it's too muddy to read. View detail