【MRA】Windshield Molding Set Review
Vehicle Inspection Measures
MRAScreen is installed, but the bracket of the braid fixation is lost (often). I had to replace the braid because it was deteriorated. It is very nice that you can sell it as a lacing braid set.
Responses
Other reviews
Vehicle Inspection.
To make Japanese Vehicle Inspection Correspondence when changing to outside Screen.
If there is a certain amount of bending, it stays in place without using Clip.
I thought we could get two cars, depending on the type of car.
View detail
For Japanese Vehicle Inspection Correspondence?
I had heard from my father, a Motorcycle shop owner, that if the Edge of the Screen is on the car, it will not pass inspection. [Color] I purchased Smoke and it came on Exactly with Zero gravity products by simply adjusting the length. View detail
Consumables.
It is used for the sameManufacturer'sScreen.
I installed it for a car inspection and have been using it ever since because it looked surprisingly luxurious.
I bought it because after about 3 years, the Yellow tarnish became noticeable.
The lacing braid end bracket allows for a secure fit and has never come off at high speeds.
It is long enough to be used one more time, so I will keep it well.
View detail
for Race.
Purchased to meet Race regulations.
It can be cut to the required length with scissors for installation.
It may be roughly twice as long.
View detail
For Z900RS
I put it on so that it would not interfere with the vehicle inspection.
No particular problem with MRA since it is MRA's Screen.
The grips were quite tight, and the fit was Large strange.
The length in the photo is 40 cm use.
Clips are securely fastened without being attached.
View detail