【MINIMOTO】Chain Alignment Tool Review
The Ninja 1000 didn't need it.
The Ninja 1000's Chain pull is Eccentric, so it's not that much of a Quantity:Pair (for Left and Right) I thought I wouldn't go crazy with
After using this product, I knew I wasn't crazy.
I'm happy with that.
I changed the Rear Shaft to Chromoly, so it might not be crazy.
The same product has been released by DAYTONA, Straight, Astro, Monotaro, etc.
Monotaro is the cheapest.
All of our products are Made in Taiwan.
The bars could be a little longer.
It's a plastic Bolt, so it won't scratch Sprocket.
Responses
Other reviews
For ChainSelfMaintenance
I had been doing maintenance of the chain by myself, but I was not satisfied with the results, so I decided to purchase the equipment.
Both parallel and perpendicular can be checked.
Analogous method, but therefore reliable.
I think it is a good item to have, and I recommend it to those who do maintenance of looseness and deflection of a chain by themselves.
View detail
Among the many that are out there.
I chose this product to get Chain Alignment since I changed the Chain of MONKEY125 to Seal chain.
The reason why we chose this type is that there are many types of this type from various manufacturers, but the Screw that fixes the Sprocket to the Material:Plastic, and that was the criterion for our choice.
It is not a good idea to get scratches, no matter how hard it is to see them.
I got a 40cm Aluminum rod separately because the Aluminum rod was too short according to the reviews from other seniors.
I think it is cost-effective if it is mentally satisfying, although I think it can only provide a comforting adjustment.
View detail
Easy to use
I've been curious about Chain Alignment Tool for a while, and I got it from webikPoint!
So, I took some quick measurements, and I put the Sprocket and Chain on top of each other, and sandwich them together with the plastic screw, but you have to make sure that it's tightly fixed to the part of the Sprocket that doesn't have a hole!
The chain line seemed to be correct, but the stick that came with it was too short and I wasn't sure about it. So I went to Home center and bought an aluminum round bar. I cut it to a good length and used it.
I hesitated with the iron bar, but I decided to use Aluminum because I thought I might be crazy with Slant if it was too heavy. The thickness was 4mm.
I'll probably only use it occasionally, but it will prevent Wheel from being uncomfortable sideways to some extent!
I think that I was glad I bought it
View detail