【SUZUKI】Helmet Holder Review

Simple and easy to use

It is really the smallest and simplest helmet lock. I am glad that it is inexpensive. I installed it on my Honda Giorno Grab Bar. Thank you very much! View detail

Standard Handlebar (22.2mm) Mounted on

Since MOTOCOMPO did not have a helmet holder, I added it to the appropriate place in the Handlebar.
Similar ones are sold on amazon for similar prices, but the Bracket is thinner and more flexible for installation.
However, the Fixing Screw on the bracket is exposed, so if you are concerned about it, you may want to replace it with a special screw. (I think the attached screw is just a Hex Screw.) View detail

Easy Helmet holder

It is a good and inexpensive Holder, but the drawback is that you have to turn the key to close the Hook.
It would have been better if the Hook could be locked by pushing it in. View detail

Helmet holder

Option parts for SUZUKIOEM.
Fixed Band, Bolt is Material:Stainless Steel eliminates corrosion concerns.
As an OEM Product, it seems to have been sold before Large.
It is less expensive and better than what is available in Option these days. View detail

It's nice and casual.

I was looking for a helmet lock that was simple, small, lightweight, and unobtrusive, but I could not find one, and then I found a helmet lock that looked just right.
SimpleHelmet lock is a key type lock that is highly universal to fit on the Pipe Handlebar, just like the OEM lock of SEA BASS. (Key case is reappearing)
I purchased it immediately and installed it. It can be installed with only two HexBolts and seems to work fine as is for a short time. (Security measures are necessary when using it for long periods of time.)
The installation took a few minutes and a lot of time, worrying about the mounting position and angle, but it fit easily by the LeftMirror Holder.
It is a SEA BASSOEM Product that is light in operation, can be locked securely, and is easy to use without getting in the way. (It is SEA BASSOEM, but the texture etc. seems to be KawasakiOEM)
The Bolt and BodyReverse side of the unit is particularly prone to rust, so it is recommended to lightly cure the exterior with Chain Lube etc.
Nevertheless, I think that this workmanship with this content is the strongest cosmetically compared to other Helmet locks. View detail