【ACTIVE】Adjustable Throttle Wire for TMR Carburetor Kit Type-2 Review

Mounted on FCR Carburetor Body37

I know this Throttle Wire is for TMR only, and I'm going to install it on my FCR Carburetor Body37! I purchased this wire.
Quicksilver Pong! You can't put it on.

I have an ACTIVE high throttle TYPE 3 attached to it. And now that we have installed FCR Carburetor Body37 Carburetor, we have a new Throttle Wire.
Because the screw cut portion of the WireOuter on the Carburetor side of this wire is short, there is no room for it to hang on the stay plate portion of the FCR Carburetor Body.
Therefore, this KEIHIN10.Stay plateCOMP" The only way I could think of to do this was to shave the Throttle Wire attachment part of the bracket, so I cut it.
First, I was cutting with a Tsubosan Bright900Series FlatFile, but that took way too much time! I took out the sander and shunted cutting. It was easy to sharpen. I wish they would release an Outer with a longer screw cut for the FCR Carburetor Body. View detail

Accelerator wire replacement at regular maintenance

Usage:TMR-MJN38Φ-Used for Touring

Image of what was received:no discrepancies

Installation difficulty:Beginner

After using it:great and slippery, I bought the same one with regular replacement.

Included Parts:OK,

Disappointments:None View detail

Easy to Linkage with a dedicated MODEL!

The product has been used for 7 years and has not become lighter after maintenance, so it was replaced
Because there is no Adjuster of adjustment in the middle of the wire with special MODEL, SMART
Easy to handle under the tank View detail

That's the exclusive product

Until now, we've been using the manufacturer's Universal Product Wire I had been there, but it was always too long to adjust
As you would expect from TMR, I was able to install this product with no problems and the length was adjusted just right And it was over quickly View detail

Stainless's dull shine is good

Formerly TAPE 1, the Gold genus was Plating.
The new one is beautiful, but after 1 or 2 years it has been found that corrosion comes out on the surface and this is also noticeable, because it's on Handlebar (* ≧ ∀ ≦ *)
When polishing it with METALCompound, copper plating under Chrome plating can be seen and it is unnecessarily anxious, (≧ ∀ ≦)
It seemed that there was not any problem in Wire itself, but I replaced it, it is slightly expensive, but if it is Stainless, I do not have to worry about rusting. View detail