【amon】Mini Flat Type Fuse Power Supply Review

Almost good, good product.

I was able to allocate it without any problems! So far so good.
However, the Fuse BOX will not close completely.
The lid is covered and the claws of the Main are still hooked. View detail

For easy power pickup

Used to get power for drareco
Easy power supply from Fuse box
However, the Wiring is caught on the Cover, so a little modification is required. View detail

easy and convenient

Easily get constant power supply from the Fuse box.
The terminals are two-way, so they can be used to install multiple electrical components at once.
It is useful because it is easy to install. View detail

Power from the Fuse box

There are many ways to use your new Motorcycle with a USB power supply to make your Smartphone Navigation experience more comfortable.
Direct connection of the Battery
Connect to the wiring that runs when the key is turned on (appropriate wiring around the handlebar).
Connect to the Fuse box

Does the Harley's Battery seem to wear out more than a domestic car when it's in storage? I think that Risk is high and give up the bacchanal even with Fuse if possible.

I thought it would be easiest to connect to the appropriate Wiring around the Handlebar, but this was also a no-no because I didn't want to mess with the Cable of the vehicle body.

Then, inevitably, let's get the power out of the Fuse box! That's when I came across this product from our friends at DIYUser, Emon.

First of all, check the Ampere number of the Fuse that takes power, and confirm the conformity of Emon. The installation is completed only by removing and inserting the Fuse.
The Ampere number for this product is
・7.5
・10
・15
・20
・30
I had a 15A in my Harley (XL1200S).

Harley has a Fuse box at the bottom of the Seat, so you can remove the Tank etc. and run the Wiring neatly to the Handlebar and it's done. After that, use the USBQuantity made by DAYTONA which I have purchased separately.:Combine with the power supply of the Set and it's done.

I have to get this stuff on.
・Tie Band
・Pliers
It's easier to do a lot of things if you have

It is still a short time after using it, but the Fuse is attached, and the power supply is excellent in cost performance without a problem because it is properly removed.

In contrast to the latest motorcycles, when a motorcycle is already in the old-school range, taking a new power supply is likely to put a lot of stress on the Battery and Wiring. In order to avoid unnecessary troubles, it is important to avoid modifying the original wiring as much as possible.

It has become commonplace for motorcycles to be equipped with smart phone navigation and draco systems, and it has become a customization to figure out how to get power to the bike. I'm going to try Challenge with a different mechanism.
View detail