【BABYFACE】Shift Arm Review
I purchased and installed this product in conjunction with the conversion to YOSHIMURA X-TREAD.
[How is it used?
I bought this product to replace the OEM shift arm for the Yoshimura X-TREAD (Rear Sets).
I'm putting it on.
Was the one you received as per Image?
Image is correct, OEM RubberBoots were also able to be installed.
Was the installation difficult?
Because there was not much play, I felt it was hard to put in when I installed it, so I hit it with Plastic hammer.
How was your experience with it?
It is tightly and looks good.
[Included Parts:were they on?
None
[Was there anything that disappointed you?
There is no installation instruction manual.
YOSHIMURA X-TREAD is almost the same as Baby Face's Rear Sets, so this Shift arm can be used without any problem.
I bought it because I thought it would be a good idea. The texture is good and it was a good decision to install it.
Responses
Other reviews
a little satisfied
It feels more like a firmness or a solid Image. Low to N/2 to N is easy to enter.
I don't know how it will look when you get used to it, but it is an Image with a few dozen kilometers on it. It's not a poncho, so it's a product for people who have some knowledge about it. If it were a little cheaper, it would be a hit product.
View detail
It's expensive, but the Shift is chunky.
It makes a solid shift feeling, recommended. View detail
Shift feel is better.
I was wondering if it would be possible to make the Shift feel a little tighter.
To be honest, I was skeptical before purchasing the product, but it is clearly rigid and
It improves the Shift feel so much that it feels nice and tight.
YOSHIMURA X-TREAD (Manufactured by Babyface) It is also a perfect match for
Then there is the price.
View detail
[Note] Not compatible with HAYABUSA after 21 model year
As stated in the Title, it will not fit the Type 3 HAYABUSA from '21 onward. The rod end of this shift arm is a Normal Thread Screw and the end of the OEMShift rod is reverse threaded, so it will not fit in the first place. If you must use it, remove the black part of the OEM rod and purchase a long nut and an extension stud bolt separately. View detail
As a product, it's top grade, but as a commodity, it's...
I wanted the Shift change to be rigid...I bought it with my B/S purchase (at my own risk).
I can choose Male or Female for the rod end, but both are Normal Thread Screw!
21Hayabusa is a Female Opposite Thread Screw, so after purchasing Monotaro. Buy at! Since it is only SmallParts, the shipping cost was high and it became an expensive Parts..............................
The OEM Arm is PeLePera thin and has a lot of rattle in the moving parts, but if you don't use Shifter, it's OK!
The aluminum machining makes it rigid and solid, and the synergistic effect with the B/S gives a smooth and clear fee ring for shifting in and out, up and down, and a pleasant feeling!
Cost performance is 1 star because the Normal Thread ScrewOpposite Thread Screw cannot be selected and must be purchased separately.
View detail