【YAMAHA】YAMAHA OEM Magnet Puller Review
As expected, OEM Product
[How is it used?
TZr250R (3XV) I used it to remove the Flywheel from the generator in
There are cheaper MagnetPullers made in China, but I chose this product because it is an OEM Product, which is mentioned in the service manual.
Was the one you received as per Image?
As you can see in the picture, it came in a bag that looks like an automotive tool bag.
I would have preferred a box because I'm sure it will sleep in the toolbox for a while after one use, but oh well, it doesn't matter to the function.
How was your experience with it?
TZr250R (3XV) I used it after removing the Nut from the Center, following the service manual for
When I turned it with MONKEY Wrench and Glasses Wrench as shown in the picture, I was able to loosen it quickly. That's OEM Product.
I think that the frequency of use is not a lot, but if it is this easy to use for less than 2,000 yen, it is good.
[Points to note]
The Handlebar that comes with it will probably be too much for this part as it requires a good amount of Torque.
If you are a person who roses Engine, I think you have Glasses Wrench, so it is safe to work with it.
How did it compare to other products?
Although I did not compare directly, I thought a little whether I would use MagnetPuller of unknown Chinese Manufacturer.
However, I decided to go with the OEM Product, which was the right decision, because the Chinese products in these tools have a lot of "hagap".
【Review】
I was able to remove the Flywheel from the generator in just a few minutes for the first time.
If you want to work with ease, choose an OEM Product.
Responses
Other reviews
Only special tools can do this.
In order to revive the immobilized YamahaRZ350, I set out to overhaul it, but the Pulley remover I had on hand was not enough to get the job done. I knew the power of the special tool from my previous experience of removing a bicycle without a co-sauce, so I searched for it and found this YamahaOEM tool at a reasonable price. The feeling is that there is no rattling, and I can put a lot of power into it. However, it didn't shake, probably because it was an old motorcycle, so I applied more force with the Expander and was able to remove it safely. There was no sign of overworking the tool, and I am glad I purchased it. View detail
It's easy to use!
1KT (TZr250) I used it in the I used the Universal Product one before, but it didn't come off well and the tool lost, so I bought the OEM Product. It was easy to use and came off easily with the OEM tool. View detail
OEMMagnet Puller
It's an OEM tool and I had no problems working with it. View detail
OEM tools for peace of mind
OEM tool with low price and reliable.
There is a similar tool made in C country, but the price is not so different and the reliability is much different, so there is no Merit to challenge.
I think it's a safe choice as long as you don't make a mistake about the type of car it fits and how to use it.
View detail
OEM tools, after all
I used to use a cheap cross-type universal puller from CHINA
I couldn't get the Flywheel out of the Universal Puller, so I had to try it out I bought the OEM tool and it came off easily
It is easy to apply force because it can be held in the mouth by a large tool
I wasted a lot of time worrying about not being able to take it
View detail