【KTC】9.5sq. Short Hexagon Bit Socket Review
Finally, a new one.
I have been using a SEK Socket that I bought more than 20 years ago, but even after applying screw lock and tightening it many times, the screw kept loosening and the bit kept falling out. The other day, when I replaced the Bolt of the Rear Sets, I damaged the hexagonal hole of the Bolt. Until recently, I had not had the opportunity to tighten the 5mm bolt too hard, so I was able to use it with patience, but I finally reached the end of my patience and decided to replace it.
The KTC 6mm Hexagon bit socket, which I purchased at the same time as the SEK 5mm socket, and which I had many opportunities to use, is still in good condition and can still be used after more than 20 years, so I chose KTC.
I turned a few bolts to try it out, and while I was not impressed, it seemed to be a safe and reliable choice.
I have a lot of inexpensive tools that I have bought over the years, but since a few years ago, I have been replacing them with more accurate ones for Socket etc. that I use frequently. However, since a few years ago, I have been replacing my Socket, etc., which I use a lot, with ones that are more accurate. In my mind, KTC is the best choice in such cases. I like KTC for some reason, but I have been using KTC products for a long time, and the fact that I haven't had any problems with them may be the Large Threshold. I think that KTC's tools have a good balance between price and quality, and I can use them with confidence.
Responses
Other reviews
It broke, so I replaced it.
Because it seemed to be tame in the Arenki for the FRotor replacement of SRX, Impact Driver + Quantity:I used a KTC 6-socket Hammer and broke it.
I bought this Socket as a refill, and this time, I sprayed CRC first, and let it penetrate by vibrating with Hammer, and left it for a while, and then loosened it, and it came off without difficulty. I may have used it wrong, but I didn't think KTC would break.
View detail
Good stuff
Because Yamaha's Motorcycle got licked with Screw lock agent, it seemed to be licking so buying a need for a firm tool. I hope there is only Kusutsushi KTC, I wonder if I can arrange little by little. View detail
I think that KTC is nice.
I often use Hexagonal for 5 mm, but I thought that I will use it someday and also purchased for 4 mm.
I want to use a proper tool because Small Bolt is so easy to lick.
View detail
Attached to Ratchet
Purchase to remove Caliper
Although I used to cheap things at the price and home center, I chose KTC with a place that is expensive as well as a place as well as good location.
Making was fresh, and work proceeded without anxiety.
This Socket seems to be able to exchange Bit, you can insert a small hexagon in the hole of the photo and exchange it for something of different size. If you buy only the hexagon part, COSPA is good.
On the other hand, it takes time to exchange, I think that it is unsuitable for those who like Smooth work.
View detail