【BABYFACE】Rear Sets Kit Review

photographic prints that you can take home with you

With OEM, the footpeg interferes with the footpeg when the foot is lowered, so I purchased this to eliminate this problem with Rear Sets.
There was no instruction manual and it was difficult to install. (Amateur work, about an hour for Small) The position can be adjusted from 4 levels,
Large Variety Satisfaction View detail

Replaced from GALE SPEED due to spec. change.

Replaced from GALE SPEEDFoot controlKit due to spec. change.
GALE SPEED has a large number of cut-out parts, and although we liked their appearance very much, we had to give them up in tears due to a combination of other parts.
To be honest, as others have mentioned, I did not have a good impression of Babyface because of the cheap Boltetc. and the use of many Bolts for position adjustment such as Shift lever.
When the actual product arrived and I opened the package, I found it to be smaller than GALE SPEED.
It could be said that the chattiness of the product led to its lightness.
Parts are individually packed, and I liked it because I could tell if screws were over- or under-assembled during assembly.
Others have mentioned that the exhaust device drive wire interferes with the exhaust, but I have addressed this by wrapping the wire around the Colgate Tube as shown in the photo.
After the installation and test run, I wrote about how I thought it was too small and how I felt about it.
I was concerned that the use of a large number of Bolts might make it feel clunky, but there was no unreliable feel at all.
I knew it was because Babyface's products are designed to be used in Race.
I personally like the color Large Osaka Gold, but I thought it looked meh when I saw it installed on other people's motorcycles while touring, but when I installed it myself, it had a strong presence and lifted my spirits. View detail

Parenthesis OK

I replaced it for use at Circuit.

Anodized is Parenthesis good.

Installation can be done according to the Instruction Manual.
It's easy

No processing was required.

Position can also be changed, as the range is large.
It was a challenge to get Shift to work together.

I fell over once, but only the tip was shaved off.

Repair Parts is expensive, so we have to go to compatible parts.
Change.

It is good because it is not dedicated. View detail

It is cosy and easy to use.

It's great because it's more cost-effective than other companies and the peg is non-slip.
Gear changing can also be lightly inserted.
However, the Brake switch adjustment was Large strange.
A dedicated Spring should be enclosed.
It is also safe to say that each Parts is also Spare.
It is rather expensive, but.., View detail

A very good rearset kit

First of all, the aluminum alloy cutting process of the foot pedal is very beautiful. Secondly, the overall weight of the pedal is very light, only about 500g, compared to the domestic Moto-Tron pedal weight of about 1600g, only one-third. The final required lifting height is quite convenient to adjust, only need to adjust a screw to change the lifting height of the pedal, taking into account the needs of long-distance travel and mountain running. It is a very beautiful and practical lifting pedal! View detail