• Home
  • Product reviews
  • Motorcycle Parts
  • Exhausts
  • Exhaust Vantage
  • Stainless burning cover... (JURAN: Exhaust Wrap V)
steps-review.png

【JURAN】Exhaust Wrap V Review
Exhaust Wrap V JURAN
JURAN
Exhaust Wrap V

Fits: その他

Japanese Webike user Japan
5/5

Stainless burning cover

[How is it used?
The Stainless Steel exhaust pipe is burnt and speckled. At first I thought of cleaning it up with burn removal chemical, but it will eventually burn again and return to the same condition after use, so I decided to wrap it with exhaust wrap to hide it. The ...

Was the one you received as per Image?
It is a bit like a thick bandage. 25mm narrow was the right choice because of the tight curvature of the exhaust pipe. 50mm wide would have been difficult to wrap neatly around the tight curvature.

Was the installation difficult?
I put on rubber gloves, soaked the exhaust wrap lightly in the water in the bucket, and wound it without cutting it in advance because I did not know how much length I would use for one pc of the exhaust pipe. At the beginning of winding, I folded the end of the exhaust wrap inward a little to prevent it from unraveling. After about one and a half rolls, I fixed it tightly with Stainless Steel Tie Wrap, and after that, I wound it so that it overlapped by about 10mm while pulling the exhaust wrap lightly. The following is an example of the use of the "M" in the "M". When the wrap has been wound up to the middle, it is good to hold the wrap and turn it as if squeezing it to loosen it. When it is wound to the end, squeeze the exhaust wrap again to remove the looseness. At the last end, fold the end of the exhaust wrap inward slightly to prevent it from unraveling, as you did at the beginning of wrapping, and Tie WrapQuantity:The 2pcs were used to secure it in place.

How was your experience with it?
After starting the engine, white smoke comes out from the exhaust wrap for about 10 minutes, so you need to be careful. Even with the exhaust wrap wrapped around the exhaust pipe, it was very hot even if I touched the exhaust pipe with my bare hand for a moment, and there was a lot of heat transmitted to the heat guard. Surprisingly, the exhaust sound became a little more mild. It sounded a little muddy.

[Included Parts:were they on?
None

[Was there anything that disappointed you?
Not particularly

Other items that would be helpful
Point or hang of installation:If you just wrap the exhaust wrap while pulling it lightly, it is not loose enough, so be sure to grip the exhaust wrap in the middle and turn it to squeeze it. This procedure will take out the looseness.

Caution:Wear gloves when handling exhaust wrap with bare hands, as it is prickly and painful, and be aware that the ends of the exhaust wrap can easily come undone.

Items to buy together:Stainless Steel Tie Wrap

Show origin

Responses