- Home
- Product reviews
- Tools
- Hand tools
- Rivet Tools
- Convenient to have... (SK11: Hand Nutter)
【SK11】Hand Nutter Review
Convenient to have
I bought this to install fogs on my Motorcycle.
Pipe is drilled and the nut is crimped with a nutter here.
Easily install fog or anything else with Bolt tightening.
I do need to drill some holes with a Drill.
Once processed with a nutter, the parts can be installed and removed with Bolt On.
There is a difference in finish between with and without.
It's a solid product, and it's a good product.
The work was not difficult or broken down.
I think it's a good product
พกพาสะดวก
ฉันซื้อสิ่งนี้เพื่อติดตั้งหมอกบนมอเตอร์ไซค์ของฉัน
เจาะท่อและขันน็อตด้วยน็อตที่นี่
ติดตั้งหมอกหรือสิ่งอื่น ๆ ได้อย่างง่ายดายด้วยการขันโบลท์
ฉันต้องเจาะรูด้วยสว่าน
เมื่อผ่านกรรมวิธีด้วยน็อตแล้ว ชิ้นส่วนต่างๆ สามารถติดตั้งและถอดออกได้ด้วย Bolt On
มีความแตกต่างในการสิ้นสุดระหว่างมีและไม่มี
เป็นผลิตภัณฑ์ที่มั่นคงและเป็นผลิตภัณฑ์ที่ดี
งานก็ไม่ยากหรือพัง
คิดว่าเป็นสินค้าที่ดีนะคะ
Responses
Other reviews
To the thickness that cannot be tapped, etc
I often use a nutter for something so thick that the Tap can't cut it
Thin plates can be fixed with a bolt nut, but you can also set up a bracket on a frame or other parts The best place to do this is usually with a co-tightening on the Bolt somewhere, but it's not the best place Sometimes you really want a Screw hole
If you have one, it's a necessity because it's useful for anything and we often do diversionary parts
But even with M5, you can drill a pre-drilled hole of about Φ7, so consider the strength of the hole, depending on the location And if the hole you drilled is Steel, it's best to paint it to prevent rust
View detail