【amon】Flat-Type Fuse Power Supply Review

Easy to remove.

Power can be easily removed by simply replacing the Fuse.
I use it to charge my phone and it works fine.
I think a little modification will be needed to get Wiring out of the junction box lid, etc. View detail

Just replace it.

I purchased a Flat Type Fuse Power Supply to install a D-UNIT made by DAYTONA. Before purchasing, you need to open the Fuse box and check from which power source you want to secure the power supply, and buy the one that fits the FuseAmpere. Installation was very easy as I only had to replace it. View detail

It's easy!

Recommended for those who are unfamiliar with power supply extraction.
Note that you need to check the Plus side in the Fuse box. If you make a mistake, the fuse may be cut off. In GB250 CLUBMAN, it is OK to replace the fuse as shown in the photo, but the wiring from the fuse makes the fuse box tight. The wiring from the fuse will cause the fuse box to be tightened, but it should be sturdy and large enough not to worry about. View detail

Very easy to secure power supply

[How is it used?
In order to add electrical components, we decided to take power from Fuse, which is energized in conjunction with Ignition key.

Was the one you received as per Image?
It was exactly as it looked in the picture; it was hard to tell what the Wiring looked like coming out of the FuseBody, so that was a bit of a concern.

Was the installation difficult?
The installation itself is easy since it is just a matter of replacing the existing Ignition20AmpereFuse, but some ingenuity is required since the wiring must be routed around the FuseBOX lid so that it can be closed. Since the wiring is coming out of the FuseBody in an upward direction, in order to make it turn 180 degrees, I had to cut off a part of the pate that was heaped up to reinforce the root of the wiring attachment part, so that the wiring could turn 180 degrees without any difficulty. The following modifications have been made to allow UTurn.

How was your experience with it?
It was energized with Ignition keyOn without any problems.

[Included Parts:were they on?
There is a 10Ampere Fuse tube in the middle of the wiring. This time, it was used as it is.

[Was there anything that disappointed you?
Not particularly View detail

Be careful not to overcharge because of its thinness.

Used to remove power from the ELIMINATOR 250.
Because the tight lid is attached to the Fuse box of Eliminator, it is not possible to take out Cable, so it is processed small by Drill.

It's a thin Cable, but I haven't had any problems with it, even if I'm using a Grip heater, etc. But you need to be careful about the allowable current.

It is very convenient and easy to use for mounting electrical components. View detail