【J Trip】Exclusive V Received Set For ZRX Review
Fits: KAWASAKI ZRX1100, KAWASAKI ZRX1200, KAWASAKI ZRX400, KAWASAKI ZRX1100, KAWASAKI ZRX1200, KAWASAKI ZRX400, KAWASAKI ZRX1100, KAWASAKI ZRX1200, KAWASAKI ZRX400
Well thought out and well made.
I had been using an OEMMaintenance Stand, but I was fed up with the difficulty of making it stand up, so I used this product at the same time I purchased the WideShort roller stands.
It was lifted so lightly that it was as if it had never been there before.
Responses
Other reviews
Easy Lift
It takes all my strength to raise a ZrX1200R with a WideShort low ler by myself.
It is quite risky, but you can easily Lift using this one.
It will cost you a lot of money if you force yourself to knock it down and dent the Tank or Exhaust System.
I bought it without hesitation.
Lift volume is an acceptable height, although personally I would prefer it to be a little lower to make it easier to take the Wheel on and off.
I think that these items are necessary not only for ZrX but for any motorcycle that has a hook on the bottom.
The texture is...Plating is textured Plating and there is a lot of weld spatter,
It is better to separate it from STAND parts and not to worry about it.
I'm generally happy with it
View detail
Rubber cover comes off quickly
Rubber cover comes off easily. It was gone before I knew it.
The comfort is perfect, and I think every ZrX rider should have one, including J-TRIP's STAND.
View detail
Definitely!
It is indeed a ZrX exclusive product!
You can use it at a good height.
This will be for j-trip Wide Type only.
It cannot be given in a regular Short low ler.
Take care!
View detail
Wide range of Motorcycle
I bought this product for my ZrX1100. I bought this product because I lost my balance when I lifted up the rear and knocked down the motorcycle.
When I used it, I was able to lift it easily. I should have bought it from the beginning.
View detail
Bad weld spatter marks.
[How is it used?
Installed external Stand Hook on MT-07.
The Hook is very low, so it was introduced to reduce the force required to Lift.
Was the one you received as per Image?
Unlike the STAND receivers I've purchased, there are so many weld spatter marks that they are unsightly.
A bit of a shame
How was your experience with it?
I was able to lower the Lift amount considerably by using this.
Short roller stands can also be lifted with one hand.
(Originally, you had to put your full weight on it to Lift it)
[Points to note]
Depends on the make of car.
I think that in many cases, the width is not enough unless it is STAND of Wide Type.
(Because I use about 30mm of One Side in Crank part)
View detail