【DAYTONA】Front Brake Vise Lock Review

Used for storage and Transporter.

It is used when using Maintenance Stand and when using Transporter.
I think it is necessary to avoid unforeseen accidents. View detail

As a simple lock

Side Stand and 1 Type STAND are used to hold the front wheel in place when lifting the rear wheel.
I used to tie the Grip and Brake lever with string or Tie Wrap to keep the FBrake in effect.
There are some U-shaped products, but if they are dislodged by some accident during work, the hydraulic pressure will be released and the motorcycle will fall over. We chose a type of product that is sandwiched between the top and bottom.

The name of the manufacturer is engraved on the body of the product, and there is a non-slip surface on the part where the finger rests. When opening, the shaft is made of gold and opens smoothly. When closing, the top and bottom parts rub against each other nicely. It is made of hard plastic and solid. It does not wobble and moves well.

I have a Raflo short lever on my RALLY 50.
I was able to lock the CUB90 with a wire type Drum brake without any problem.

It was easy and fast to lock when I used it in the field. No Garbage from cutting string or Tie Wrap. Very convenient.

Prolonged use will put a strain on the brake components, and if the piston seal inside the caliper is deformed, the pad will not return to its original position. It is best to use it as a simple lock.

I tried to hang it on an old barrel-shaped grips I had on hand. I was able to hang it by pushing it in, but it left marks on the grips. It is better not to hang it on the thickest center section.
The Package clearly shows the size in full size Large under the actual item, but it would be easier to see if it were drawn on the reverse side if possible. View detail

It's available but ・・・・・

There was no description of the dimensions in the product description of the Webig; there is no description on DAYTONA's website either, and the dimensions can finally be found by opening the handling instructions.
Our car is a custom vehicle. The diameter of the hole where the grip fits is 36mm. The hole diameter is 36mm, and the width of the brake lever is 20mm.
If I had known before I purchased the product, I would have gone to ・・・・・.
The lever hooking part was also machined.
Prospective buyers should check their own car's BuRipSize. View detail

Cospa best

I use it in conjunction with MaintenanceRoller.
Light, SmallLock is sufficient. View detail

To use Rear stand

[How is it used?
This is used to hang the Rear stand.

Was the one you received as per Image?
It was confirmed by Catalogue only, but it is as Image.

How was your experience with it?
Before, the brake lever was held by a string or cable ties etc., but the installation is fast and reliable because it was developed exclusively for this purpose.

[Points to note]
It's not a Point to note, but it presses the Brake lever pretty hard, so I take it off when I'm working for a long time. View detail