【KITACO】Stainless Steel Cotter Pin Review

If you don't put it on, you'll be scared.

On the front tireShaft of the CUB

When Tire was replaced,
I didn't have a Pin on hand, so I ran for a while without a Pin on.
The front tire started to wobble and
When I stopped to inspect, I found that the shaft nut was loose enough to rotate with my finger.
Scary…orz
So I immediately bought it and stopped Pinning!

I honestly don't know about things.
Since it is Stainless Steel, it will have a certain degree of strength with little rust.
I think you can rest assured. View detail

Easier than buying OEM Parts?

Quantity rather than buying OEM Parts:1 Set of 10pcs. of this product may be useful in your tool box.
This time it was a little long and I should have cut the tip off, but it seemed to have no effect, so I rounded it off and used it (laughs). View detail

It is useful for Stock.

Quantity:1 Set of 10pcs. is a good amount to keep in stock for maintenance. Once removed, it is not difficult to reuse, but it is used for the Castle Nut, which must not be loosened, so I always put a new one in. View detail

It was used on the occasion of Tension adjustment of a Chain. Since it is not used abundantly so much, a ten-set Pack is right just.

It was used on the occasion of Tension adjustment of a Chain.
Since it is not used abundantly so much, a ten-set Pack is right just. View detail

A cotter pin is a split pin. I am using the use part here of a big split pin for the axle shaft of a rear side. As it is in a picture, it is not suitable for re-use in the split pin used once. For example, Tyre exchange. In the case of a m

A cotter pin is a split pin.
I am using the use part here of a big split pin for the axle shaft of a rear side.
As it is in a picture, it is not suitable for re-use in the split pin used once.
For example, Tyre exchange.
In the case of a motorcycle, the Tyre wear of RIA is more remarkable than a front.
When exchanging rear Tyre, the axle shaft of a rear side is desorbed.
There is a nut which ties the axle shaft of this rear side.
This nut loosens and it is using the split pin for a stop.
The size of the split pin in W650 is set to 4.0x35.
Split pin exchange is carried out also except the Tyre exchange.
It will loosen the nut of the axle shaft of a rear side in the case of chain adjustment.
A split pin will be naturally pulled out in that case.
A split pin is pulled out, a nut is loosened, a rear wheel is moved back, and the tension of a chain is adjusted.
These acts are only performed and two split pins are used.
Also when carrying out chain exchange, of course, split pins may be exchanged and you are exchanged at the time of a great car wash.
even if it is alike and uses any, although one set of sale is carried out by ten, I will completely have the product here and it will describe to the sentence end that it is not set sale by a superfluous number.
Just small components support sense of security also like Rider's feelings also for a motorcycle.
It is like [ if a simile is carried out, however highly efficient Tyre will be worn, but ] un-equipping a wheel with an air valve cap.
Also in order [ which you search for ] to have you play a role safe, having small components made differs in the sense of stability of a feeling.
As for the cotter pin of an original manufacturer's product, although it is iron, it made from a kitaco is a product made from a stainless strong against corrosion harder than iron.
recommendation goods -- rather than -- the goods which should be bought are just accessories of a cotter pin or a beta pin -- ~!! View detail