【RAM MOUNT】Fork Stem Base Review
racing (of an engine)
To install Tire's wireless Air gauge Monitor.
We chose this product, which uses Stem holes, because we did not want to increase the number of conspicuous Mounts.
I could not get the installation to work and when I repeated Cut, it went blank.
Instead of following the instruction manual, once the cut is made, the Stem hole should be filled to the Limit.
Tightening Bolt and expanding Body may work.
It will not come off, so it will be used as is.
Responses
Other reviews
Well, it shakes a lot. It might be Anti-vibration in a sense.
The price is cheap. Anyway.
It's a bit unstable, and the Image that plugs the Rubber plug into the Stem is quite shaky.
And since it's a tapered rubber plug, I think it might come loose from vibration. I've never had it come loose, but I do hit it with a hammer or something on a regular basis.
I didn't have a choice because I like Rum Mount, but I thought it could be a little more manageable.
However, considering the fact that the vibration of the Motorcycle will break your phone, this product will definitely absorb the vibration.
Perhaps this is better for you.
I think I'll keep using it for now.
View detail
If you don't mind the details.
First of all, the paint was peeling when the product arrived, which was sad, but once it was installed it was fine. As others have said, it will turn, but it's the best part of the Stem, so it can't be helped. If you don't force it to turn by hand, it's fine for use. View detail
Be careful when you remove it
After installing it, it was too spinning and unstable, so I loosened it up to try to take it off … only the Nut mounted on the back drops to the ground from within the Center bolt
Only the rubber remains in the bolt and cannot be taken out It is not possible to use it anymore
The description does not allow you to inject into the center bolt However, if you cut it into smaller pieces, it will spin around
I had no choice but to buy a different Base and use double-sided tape and Tie Wrap I use the top portion of the system in a fixed position
View detail
It can not be fixed with the installation according to the Instruction Manual
In the accompanying Instruction Manual, the Equipment Rubber plug (Conical Rubber) Insert it into the Stem, mark it in the protruding part, and 1 inch towards the direction where the tip becomes narrower from there (About 25mm) Marked the part and marked it cut in two places - - - There is, but it can not fix well with that.
When inserting into the Stem, cut the part about 10 mm further downward from the upper part, 1 inch towards the direction where the tip is getting thinner (About 25mm) Cut the part of. If you insert it in the assembled state, it will completely enter inside as soon as you plug it into the Stem. This is a miso.
Also, use Washer and Nut anchor Attachment to choose One size Small thing from Limit entering Stem. Nut that is in Set is also Nut with locking prevention, but I use normal Nut. Even if you tighten it with a loose stopper it will rotate together.
Also, when installing, it is hang to inflate the Rubber to the very last minute not to get into the Stem if you do not do your best by tightening Bolt. If you tighten in this state, you can not fix it completely to Firmly, but you can fix it quite steadily.
View detail