【NISSIN】[NISSIN Repair Parts For Master Cylinder] Repair Kit 19 Review
BrakeInner Parts
The grip of the brake was gradually increasing and I felt that the inner parts were worn out. After the replacement, the direct feeling returned and I am glad that I replaced the inner parts.
Responses
Other reviews
Overhaul of Semi-radial master
It has been about 5 years since I replaced the front master with a semi-radial, so I decided to overhaul it.
Once the master has been removed from the vehicle, remove the reservoir tank and lever that are in the way of the work, and remove the pump part only. After that, clean the cylinder part, install the new kit in the reverse order of disassembly, fasten the new kit with the snap ring provided, and fit the boot. I applied a light coat of metal rubber to the rubber part of the inner parts before installing. If you take the parts of the stock master, you have to install the supplied packing by yourself, so you have to be careful not to damage the packing when installing.
After the pump part is assembled, the lever and reserver tank are installed. After this, it's time to install the fluid in the car body, and then continue with the tedious air venting process.
I finished the whole process and did a test run, and it worked fine. There is no visible improvement, but I can use it with peace of mind for the time being.
The key point to remember when working with these parts is that the boots are new in the kit, so you can handle them roughly if they are difficult to roll up. However, the white plastic parts in the center of the Inner Spring are not attached to the Kit and need to be reused, so you need to handle them carefully.
Needless to say, Brakes can be dangerous if they malfunction, so if you choose to Rose them yourself, do so carefully and at your own risk.
View detail
It's nice to have maintenance parts.
I replaced the internal parts of the Nissinsemi-radial 19mm MASTER that I was using as a replacement for the OEM Brake master that had rusted and deteriorated with a new Repair kit.
The Repair kit includes the Material:Plastic lock pieces are not included, so I'll replace the old ones with the new ones.
Apply Fluid to the Cylinder Seal and Grease to the inside of the Dust cap. There is a possibility of getting small Garbage in the cylinder because it is outdoors.
View detail
There is no problem in particular.
I used it for Overhaul of my semiRadial master cylinder. There is no particular problem for dedicated Repair Parts only. As Fe Ring after Overhaul, the operation became smoother and the sense of Direct increased. I aimed for further improvement of fe Ring, polished and attached the contact part with Piston rear end part, Brake lever. View detail