[Manufacturer Parts Number] 08U70-K2E-J00 [Specification] Usage Range: It can be used up to the rated 12W (12V1A). Mounting Position: Left part of the meter Installation Time: 0.1H [Included Parts] with Waterproof Cap
*Cannot be installed at the same time as the grip heater. *In order to prevent the battery from running out of power, use the product with the engine running. *Some products may take longer to be delivered. *There may be changes in product specifications due to manufacturer's reasons.
Pocket Accessory สำหรับชาร์จอุปกรณ์ไฟฟ้า.
Pocket Accessory for charging electrical equipment.
HondaOEM's Socket and iphoneSE will run out of battery in less than half a day. I think it's because the iphone doesn't have that much battery to begin with and Navigation eats up more electricity than I thought. I know this is off topic, but if you are going to be doing longer touring, the Socket is a must. I think webike is a better deal for the Points than Honda Dealers!
It is OEM Attachment part, so the quality is good. However, it is not USB port type which is popular nowadays, but Cigar lighter type. Is it a common attachment part with other Honda cars? There is no instruction manual for installation.
Finally, the CT125 CT110 HUNTER CUB was delivered today, so I bought it in Large quantities. Start installing certain outfitting items.
Naturally, we'll start with the electrical Attachment. I don't even think I'm going to go running without my Navigation replacement, Ta-Brett, sitting on the ground. because it is not there.
There is a special slot on the Key cylinderLeft of the Top Bridge, and the Grommet This is a perfect fit when you pull out the As expected from an OEM product, there is no positive reason to choose any other product If you want unlimited Ampere, just use Battery directly.
The included rubber cap fits really well and will not come off on its own at all.
There is no instruction manual and Attachment feed to the Manual of CT110 HUNTER CUB side. No mention of Coupler. Short Harness and WaterproofCoupler, so you can use it from the Top Bridge There's definitely a pair of Couplers in the not-too-distant position! Think ………
I looked into the back of the Headlight Assembly but could not confirm it. Then! I removed the Frame cover and checked the Battery, but I couldn't see it.
The correct answer is inside the Headlight AssemblyCase & omega; Here, a pair of water-proof couplers of the same color sit with a Blind lid. It was.
Remove the headlight unit with the coupler and try to pull out the Blind cover, but it is not possible to remove the headlight unit. Terribly hard to get out of ……… In any case, I have no intention to reuse the Blind lid or anything like that, so I'm going to use Nipper for the nails from the beginning. It would have been quicker to chop it off & omega;
By the way, the ManufacturerOEMGrip heater also feeds this power Since it uses the WaterproofCoupler, the combination of these is not technically possible. Of course, I don't think the 125 single-cylinder Generator will force you to do anything, but it's a bit overprotective. ? I'm a paranoid and my wrist is damaged and I don't use a grip heater because I prioritize the anti-vibration Gel grip. I don't have one, but ω
I thought about making the direct Battery wired for convenient charging in Garage, but this time I also decided to make up Harness for Charger separately. The CT125 is going to be my last toy, so I didn't want to push him too hard from the start.