CB400SF -21 (NC42-2000001-)
CB400SUPER BOLDOR -19 (NC42-2000001-)
CB400SUPER BOLDOR 2BL-NC42 NC42Eดูเพิ่มเติม
I attached the SSB Bumper, but apparently I understood that SSB can not protect Crankcase. So I installed this product additionally.
Because the place to install is the Engine Mount part, it is rigidly rigid.
I had to tighten the tightening with a high Torque, but the Screw on the other side was going around together so it took quite a bit of trouble in the installation work. There was a place where Ratchet wrench can not be used in plain form, and it was also Large strange. Since this product is HONDAOEM, I think that it is good to have it installed in the shop.
It was attached when I bought it in second hand.
I got about two go-stands, but the engine was intact.
However, Mirror cracked Cowl cracked, Brake lever broke.
It is natural for you to drive, but when you knock down you get stuck on the ground (Considerably earlier than footpeg).
So I will not recommend it for people who want full bank.
I think that it is good that people who just run normally do not have much noticeable.
First of all, it is good that Size protrudes a little from Engine and it is inconspicuous.
It is a fluffy OEM Product.
However, the Instruction Manual was not included in the delivered item.
If you can just attach it, you do not have to follow the Instruction Manual, but Torque did not understand and I twisted 10 mm.
I bought 10 mm at Home center but I am a little anxious about screw durability.
It is good for missing impact
Also installation of 10 mm of Right Side is troublesome
The worse one is long, but it is good as a thing