I purchased JSM Aluminum Billet Footpeg board Hole cap for fixing.
The coloring of Anodized is good and the satisfaction level is high.
Since Color line nap also has 7 colors, body color etc. etc. I think that it is easy to match with.
I think it is expensive as it costs more than 300 yen per Bolt 1 pc, but I think that BoltCustom got a sense of coming out so it's not a waste.
Just replacing OEM's undiscovered Bolt with Bolt with anodized finish, it is recommended because you can turn on Accent.
? 【What made you decide the purchase?】 Bolt I always use quality well. This time we replaced all Bolt of Engine Cover of WR 250 R
? 【How was it actually used?】 Precision reed, Anodized is also beautiful
? 【Was it difficult to install? (Hard parts case)】 Apply heat-resistant Grease and apply
? 【Please tell me the point of installation and hang (in the case of Hard parts)】 Unlike OEM, material is different, so overtightness = break. Especially long Bolt is attention because Screw is easy to cut.
? [Is there anything I was disappointed about?] The color of Anodized is different when the date of purchase is different. Manufacturer Although I already have it, should you order more than one if you exchange more than one
? [Request to Manufacturer - Please tell us if there are any improvement points】 When used on painted surfaces such as Engine Cover, the back of the Bolt head, the contact surface is not chamfered and the other's paint can be peeled off. C0. I would like a chamfer of about 5.
? 【Have you compared items?】 Quality is inferior but price made by DRC
? [Others] The third piece of photograph is different Anodized color difference of six months purchase difference. Although purchase is Blue, there is a difference between dark Blue and slightly dark Blue.
Although it was installed in WR 250 R this time, I ordered the necessary number because I had set sale, but there was impression such as Bolt shortage.
Is it a reference?
M6 30 mm 19 books
M6 35mmQuantity : 2pc
M6 80 mm 4 books
M6 25 mm 4 books All except the Oil Filter can be exchanged. However, as there are two places with Copper Washer, OEM Product No. 90430-06014 is also required together.
Blue and Red Bolt will shine on Silver's Engine
With your favorite Bolt, this time I tried to exchange Cover bolt of RMX.
There is set sale, but ChocolateChocolate and other Bolt are also exchanged so we only ordered the necessary parts at Rose.
When installing heat-resistant Grease, it is GOOD because Torque will also be applied uniformly. In addition, as OEMBolt sometimes rusted the axis well, so also to prevent it. (I am using Pad grease)
When Length became about 50 mm, there was a feeling that Bolt would stretch pretty much by tightening, so be careful with over tightening. It seems that Screw seems to be getting better from the threaded position than All Screw. For now, this Manufacturer's Screw has never cut off, but the DRC made a few times more than the Screw's Screw drilling clothes a few times.
Completely self-satisfied, but lonesome Engine will shine a lot
I used it for DJEBEL 250 XCOil Filter Cover. Since Length is 75 mm, it is a waste, but I cut it about 5 mm and used it. You can cut it easily with Grinder, but you want a Variation with a length of 5 mm in units of 5 mm.
Although it is also on sale from Takegawa, I made it to this product which can be obtained in a few days by Cancellation which takes considerable delivery time.
It is as usual, including complaints of texture, but I ordered 25 mm this time, but plenty of strength pledged. I do not care because it is not installed side by side, but I want you to make the color more uniform from the price.