Reviews
From Scooters to Large Motorcycles
It's a little bit inconvenient because it doesn't have a fine scale, but it works fine. large size is easy to handle because large threshold jug is troublesome to wash and store. View detail
Buy at Oilfor Replacement in MONKEY
Because the amount of oil use is 900ml, I was looking for the one of the small size for 1? When storing, the tip of the hose and the spout also have a gap, and the place where the contamination of garbage etc. can be prevented is good, but because Oil does not fall from the Filter of the spout easily and the spout is slanted, Oil flows to the hose when measuring 900ml, and I felt that it was unexpectedly troublesome. I felt it.
If it's 900ml, I think it's easier to remove 100ml from the can and use Bellows to clean it.
View detail
For Gasoline Refueling
[How is it used?
I bought this for Gasoline refueling at Circuit.
I use it to calculate fuel consumption and to set the fuel to the smallest limit before the Race.
Was the one you received as per Image?
Image is correct, I use the same one for Oil.
How was your experience with it?
It has become the most recommended jug with lid and Cap at the end.
Garbage is hard to get mixed in, so the one I use with Oil won't get covered in dust and junk as long as I keep the lid tightly closed.
[Points to note]
When pouring, be careful not to close the mouth tightly or it will leak.
How did it compare to other products?
I recommend it with a lid and a Cap on the end to keep it clean and ready to use.
View detail
ดีมากเลยครับงานดีกว่าที่คิด ถ้าเป็นฝาแดงเหมือนในรูปจะดีกว่านี้ View detail
Expected
[How is it used?
I used it only once to change the engine oil.
Was the one you received as per Image?
It was smaller than I thought it would be.
How was your experience with it?
Until now, engine oil has been used in the lower part of the engine.
I had to adjust it while staring at it, but it was better to put it in after measuring it well.
It's convenient and gives you a different sense of security.
However, one thing that I thought I failed was that my Motorcycle, SB250, was
You need at least 1.2Liter when changing Oil, so you need to divide Oil into two times.
It's something you have to put in.
1.I should have bought a product that measures up to 5 liters...
[Points to note]
The lid is attached as an accessory, but it doesn't close that tightly.
Not to be used for spilling liquids.
Use it to prevent dust from getting in during storage. (Failure to do so)
How did it compare to other products?
This is my first purchase of Oil Jug, so I have nothing to compare it to.
1.If you have a 5Liter product, buy that one.
View detail
Just the right amount of Large
I bought this for my CT110 HUNTER CUB to do the oil change myself.
Not too much, not too little, and it's for 1L.
I decided on this product because it has Memory, a lid to prevent dust from entering during storage, and a Cap on the spout.
The hose on the spout seems a little too long, but it's easy to use.
View detail
Oil is vital for both cars and motorcycles
This is the main oil replacement for cars now, Busa, cbr1000rr, TENERE700, cb650r also use this 2liter, 200cc, 1liter thing and measure the amount well. We use YAMALUBE synthetic 10W40 for motorcycle and Shell for car, so we wash the car oil and motorcycle oil after use to avoid mixing them. View detail
Let's measure exactly how much Oil we have.
We use 2 kinds of oil, 1liter and 200cc, because too much or too little oil can damage the engine. View detail
The capacity of the 250cc Motorcycle is just right.
[How is it used?
Oilfor Replacement
Was the one you received as per Image?
It was stronger than I thought.
How was your experience with it?
With a 250cc Motorcycle, the capacity is just right.
[Points to note]
If you have a four-cylinder, large type, it is smoother to buy the Oil Jug of large threshold size.
How did it compare to other products?
Cheap
View detail
Easy to get in!
I purchased this for use when changing oil.
The scale makes it easy to measure the right amount.
In addition, the spout is thin and easy to pour.
It also comes with a Cap so your Oil won't drip when you're storing it.
A Cap is also included at the point where you pour the oil into the jug, so there is no dust buildup in the jug.
View detail
If you want to change the oil.
【good point】
An easy-to-use 4-liter jug.
Motorcycle Oil is Large body and this size is just right.
[Bad point]
nothing special
[Summary]
If you use a jug when you change the oil, it will be less likely to spill and
You can manage the quantity properly, so if you often replace it yourself, you'll want to have it.
View detail
Compact size and easy to use.
It's easy to read the scale and it's convenient to check the amount of oil in the jug when you transfer from the oil can to the jug. View detail
Not good for the price.
I bought this product to see how much oil I need to change, which seems to have a good reputation.
It seems to be a bit hard in terms of material and seems to deteriorate and crack quickly. This is a good product.
Nozzle is also hard and difficult to use, in my opinion, in terms of bending, etc.
Also, if you don't use the Nozzle, it's fine if you can store it inside, but the Nozzle is so hard that you have to force it out or it won't fit.
View detail
Cheap and effective.
It has a lid to prevent Garbage from getting into the jug and it is convenient for storing engine oil. View detail
Of all the Oil Jugs I've ever owned.
This is the best Oil Jug I've ever had.
The spout is small, just for Motorcycle.
The one at Homsens has a thicker spout and a shorter bellows, probably because it's intended for automobiles.
This is essential for motorcycles that have small oil inlets and are located in intricate areas.
View detail
Convenient and easy to maintain. (* 'Ω `*)
I bought two of these for the maintenance of my CRF150R, one for engine oil and one for gear oil.
I didn't want to have to go through the trouble of checking the level gauge many times when I put the oil in the oil can, so I measured it out and put in about 80% of the specified amount of oil, and then checked it twice to make sure that the oil was injected properly.
Because it is with a lid, it is glad that dust and Garbage do not enter when storing.
I have used it once and kept it by just lightly throwing out the oil inside, but it does not show any deterioration, including the bellows part. I have been using it for about two years in this storage method.
The price is a bit high and the spout doesn't fit in the spout of my motorcycle, so it would be easier to fill it if it was 5mm thinner.
View detail
It's easy to use for Almighty!
It is very easy to adjust the amount of engine oil.
It is a small type and takes up very little space for storage.
After use, I clean it with Parts cleaner and prepare it for the next oil replacement.
View detail
Convenient to have
It is used for both Oil and Coolantfor Replacement.
I appreciate the part of the lid that prevents foreign objects from getting into the storage area. I think it's easy to use.
View detail
It wasn't as good as I thought it would be.
I don't want my oil jug to get dirty, so I wanted to find a jug that could be used and stored nicely. I don't want to have to worry about it getting dirty, so I wanted to find a jug that I could use and store nicely. Purchase.
It has a lid, so I wonder if it will prevent dust from getting in during storage. I thought it was a good idea, but it was no good because it was pretty chancy.
I bought a KITACO Oil Jug after this, but this one is solid and has been used for a year. It's in there and it's working beautifully.
View detail
Maintenance essentials
The Oil Jug that I used to use, I think it was purchased at Home Center's Car Parts Corner I bought it because I ran out of Bellows in the Nozzle section. In OthersMaintenance, it is very useful. When storing, you can put Dustclothetc. in it to keep Dust and Garbage out of it. I think it's good. View detail