Reviews
Recommended for people with thin legs
I think the design and texture are good. The fabric looks durable and seems to have good protection performance.
The suspension has a slim Fit feeling and there is no flapping, but I think it is tight for those with thick legs.
Since the Knee Protector is a three-dimensional and bulky Type, changing to a thinner one would reduce the tightness around the knees.
Waist size can be adjusted with Velcro, so they can be worn without belts.
Personally, I would like to move the Knee Protector up another 1 or 2 cm or so.
We drove during the day when the temperature was 28 degrees Celsius, but it was cool and comfortable with a breeze.
I think the leather lining on the inside helps to provide a good knee grip and helps to block out heat from the motorcycle.
Riding performance is good and is recommended for those who do not have thick legs.
View detail
Used for DT50Mirror BracketBoots.
I replaced the MirrorBoots on my DT50 because they had deteriorated. To replace the MirrorBoots, remove the screws from the MirrorBoots, remove the MirrorBoots, and install the MirrorBoots. View detail
Half Finger Gloves
In the summer, when removing gloves from hands, it was difficult to remove them when they were sweaty, but this product has an original loop for removal and can be taken off smoothly.
The fit is a size M, but it is slightly large.
View detail
Size selection with room to spare is recommended.
I had been using DEGNER's Porch, which is compatible with P.A.S. Mount, and purchased it to install it in a vertical position in combination with Meter and other equipment due to a change of vehicles.
Back provided for Camera [Color] It is a Clear window, but it also has a secondary use through which you can see the meters on the other side of the Porch.
The size of the iPhone I am using can fit in the Smallest Type of the same series, but this size was the best for me because it allows for more room when considering Cable's handling.
View detail
Windproof enough for early spring
I am looking for a pair of gloves to use in early spring. I chose Wind guardSpec. which I have purchased before.
I chose XL size so that it would not be too tight like the Ruff&Road Winter Gloves that I am currently using. However, the thin interior of the LL was not too tight, and I felt that it would have been sufficient.
As for the windproof effect, I went to a mountain pass with snow remaining in early April, but my hands did not get cold and I was able to concentrate on driving.
The Knuckle guard of Carbon, which is the standard rough&Road, provides a sense of security. The design is red, but I think it would have been better if it had more red parts and was a little more flashy. This is my personal feeling....
Overall, I think it is cosmetically good considering the Guard, wind resistance, etc. I can't say what else I can say because it is a matter of taste, etc., but I think it is good for running in slightly cold weather in early spring and fall.
View detail
Good vibes
It is a little difficult to adjust the movement, but I am satisfied. View detail
Does a surprisingly good job.
This is an inexpensive Chinese Case that I have seen on some Site. (Although it has the company name of "Rough &Road" on it.)
It is inexpensive but does the job well. (For now)
It is installed on CT125CT110 HUNTER CUB (JA65), but it seems that Attachment for CT110 HUNTER CUB is not necessary separately and can be installed.
When the case is installed and the Center Stand is applied, the front of the case rises up like Seesaw. (Rear load Large)
Case surface is pear, satin, matte, textured and very dirty. Dust sticks to it.
View detail
Warm is warm
I bought it because my Over Pants that I had used for years were falling apart. the Size may have been wrong, but it was not unusable, so I used it.
It is so easy to put on and take off that it is a big surprise. I thought it was wonderful that I did not have to take off my shoes. On the other hand, I felt a little uneasy because some parts were exposed.
My fears were proven true. The draft was cold. The protected part is warm enough to be hot, but the exposed part is cooled down by the wind. This is how it feels at low speeds in town driving, so the situation may change as the speed range increases.
View detail
Cospa good
I like the Converse-style design and the fact that they are not for riding.
The texture is not bad and it is easy to wear.
View detail
It does a good job except for the fact that it is not a good job.
This is an inexpensive Chinese Case that I have seen on some sites. (It has the company name of "Rough &Road" on it, though.)
Inexpensive but does the job well. (For now)
It is installed on a CT125CT110 HUNTER CUB (JA65), but the Attachment for CT110 HUNTER CUB is not necessary and can be installed separately.
It seems to be possible.
When the case is installed and the Center Stand is applied, the front of the case rises up like Seesaw. (Rear load Large)
Case surface is pear, satin, matte, textured and very dirty. Dust sticks to it.
View detail
The quality, functionality, and cosmetics are excellent!
The stiffness is a little, but it doesn't interfere with riding at all, the knee pad is just right, and the protection is perfect! I felt it was not expensive. I like it very much and it goes well with the Shoes I won before. View detail
Recommended for those who continue to ride in the middle of winter.
They are expensive, but they are really warm and I sweat after getting off the motorcycle, even in the middle of winter. They are so thick that I can only wear them with loose-fitting pants, "I'm kind of invincible now, aren't I?" It makes me feel like I'm in a good mood. However, you may have to be a little careful about washing after taking them off because they make you sweat. I recommend it to those who continue to ride in the middle of winter. View detail
Fits: HONDA CC110, HONDA CC50, HONDA CT110, HONDA CT125, HONDA CC110, HONDA CC50, HONDA CT110, HONDA CT125
Very cool under the buttocks.
After parking under the blazing sun, it is sometimes uncomfortable to sit on the Seat because it is so hot, but this Mesh cover helps a lot. The MeshMaterial itself does not hold that much heat, so you don't feel it as hot.
Besides, once you start running, you will feel very cool under your buttocks because the wind will be blowing through the 3D MeshMaterial in a nice way. It is too cool when the temperature is low. It might be better not to use it in spring and fall (Lol) Of course, you'll have to leave it off in the winter.
Note that MeshMaterial is more slippery than SeatMaterial, so the holdability of the buttocks will be a little lower. Also, since it is 3-D Mesh, it is thicker and the seat height is about 2 to 3 cm higher, so please be careful about the footing.
Also, Seat shape and the shape of this product. (circular) is not Fit, so some may be bothered by the feeling of doubling up at the aperture on the front side of the Seat when it is covered.
View detail
rather short
I was not sure about the Type, which has a removable Inner, but I decided to buy it for winter use only.
The tightness of the Storm guard belly band and Waist belt makes it easier on the lower back.
I would have liked the hem to be a little longer, but when I ride my Motorcycle, my ankles stick out. Even if I stopped the anti-slip-up loop, it came off due to the absolute lack of length. It was a shame because the rest of the garment is good.
View detail
A reliable Brand Gloves as expected
Update on 5Season used GOLDWIN Winter Gloves with holes in the fingertips.
Since it is the end of the season, the stock is limited, so we chose ROUGH & ROAD, a favorite of 3SeasonGloves!
The leather material is a little hard and firm, so much so that it takes a lot of grip strength just to goop it up at first.
I'm hoping that as I use it from now on, it will fit in better.
The thermal performance is about the same as GOLDWIN, but in midwinter cold, I'd say 30 minutes is the limit.
View detail
Role as an Inner
I didn't feel that much warmth, personal opinion and suggestion, but I would like to see a design with a longer length and a lower length like the Baseball Underershirt, or quilting on the stomach and waist for added warmth. View detail
It can be used with a turnstile.
I bought this to attach my old Porch and Smartphone Case to my Scooter.
As others have stated in their reviews, it rotates when installing the Porch and other parts.
I solved the problem by adding a Nut to stop the loosening.
Because of its high quality, the appearance of the product without Porch and other products is not bad.
View detail
Mystery Spec. but not bad.
Was the one you received as per Image?
As for the 38mm width Leather belt, it is as shown in the Image.
It was unexpected that the buckle section was arcing against the curves of the body, not along them.
The surface is a general leather belt texture, just like the Image.
The reverse side was a little crusty and did not change after applying oil, so it was not expected to feel different to the touch on the reverse side.
[How did you feel about the Fit?
It is not uncomfortable as a wide Belt, and it is usable as usual.
Buckle was a mass of discomfort from the structure against the body and the interchangeable spec. so the original Buckle was never used. HONDA×KUSHITANI]Garrison Belt:https://www.webike.net/sd/24605446/ It was used by converting it to the one of
How was your experience with it?
Duration of use:Continuous use from approximately March 2023 to March 10, 2024.
Worn clothing:Uniqlo or Muji Jeans
Frequency of use:High because I use it every time I go out regardless of whether it is for motorcycle or private life.
Very, very ordinary, Belt.
The company name and manufacturer's logo are printed at the base and tip of the belt, both of which are still firmly recognizable and have not been crushed or chipped.
[Was there anything that disappointed you?
The back surface of the tip of the Belt is rough from the appearance, including the fact that the back surface was crumbly, which makes me a little concerned about the durability of the product. However, there is no problem with the appearance of the back surface when using it, and we have not observed any peeling on the grain.
What are the specs of the product, such as protector?
Buckle itself is a mysterious Spec. that is interchangeable from the start.
PackingButtonQuantity made of Gold genus:2pc. Set only, so no tools are required for implementation.
Once the buckle is replaced, it will never be changed again, and since it is secured with Screw Lock agent, it is not known if accidental removal will occur.
The buckle attachment area also has a little room, so you can basically expect a 38mm wide buckle to fit.
Belt holes are 3mm long×4mm wide and oval in shape. However, by continuing to use the same hole, it can be widened enough to pass through an eyelet with an inner diameter of 7mm.
How did it compare to other products?
・ HONDA×KUSHITANI Garrison Belt:https://www.webike.net/sd/24605446/
The two companies share the same belt width, price, and the fact that they are made by companies related to motorcycle accessories, but the Logoetc. company is printed and with color on the other side. The durability of the Logo is superior to the other one, as the paint inside the Logo may crack with continuous use.
The texture of both sides is the same, and the other side is not shiny, so the durability is probably better than the other side, but both are made of leather, so they will last for a long time.
・EDWIN
I think I bought a Belt of the same width for about the same amount of gold, but this is the only one that adds the Motorcycle element to the Belt product, in that it is made by a Motorcycle product manufacturer and has Logo on it.
[Deciding factor in desire to purchase].
The color scheme was similar to that of YZF-R6 with Stitch's combination of Blue and White. Also, because it was a BlackBase and a non-synthetic leather belt.
Even now that I am using the product, I have no idea why it became a Spec. with interchangeable buckles, but when I port it from a Belt of the same width, I can use it without any discomfort at all with the previous Belt, which may result in a product that is more flexible and easier to use.
View detail
My concern is that the collar looks too high and hot.
Immediately after the arrival of the product.
I'm 163 cm, 55 kg, so I'm Exactly in M.
Texture is good.
I've seen last year's model at a retailer, but it was knitted in a Large size and had no waist.
The upper arms and shoulders of this MODEL are made of a fine mesh fabric, so they are sturdy.
The ROUGH & ROAD Logo is discreetly included.
Personally, I would prefer a smaller size.
My concern is that the collar looks too high and hot.
Komine I am wearing a JK-128 and the collar is very low but it is hot and I will be running with the Fastener down so I will have to run with the collar open.
View detail
Load capacity has been increased.
I bought it to carry my backpack, and the extra width of the carrier makes it more stable and gives me more room to sit. View detail