Reviews
Fashion and dirt prevention around the Rear
I think it is a good thing as a thing. However, the price has gone up by about 30,000 from a few months ago.
And the Carbon mesh is messy for the price. (?) I was disappointed in some areas. For me, it was I suppose it's not a flat part, so what's the point?" I told myself to give it up.
View detail
So-so...
I think it is good for preventing scratches because it can cover the Tank.
I would have liked to have had the unglazed Carbon if possible.
Installation was very easy since it was done with double-sided tape.
View detail
Double-sided tape is not enough.
Double-sided tape is included, but it is a thin type and not reliable. I reinforced it myself with 3M thick tape for vehicles. View detail
To improve serviceability.
Since the other Cowl Fastener was not a D-Ring, I purchased the D-ring Fastener from CLEVERWOLF for improved serviceability.
As a result, it was not possible to use the Fastener because the diameter of the Fastener of the original cowl of other companies was larger than the Quick fastener that was purchased this time.
It turns out that it is rattling, and was informed here that there was size in Quick fastener, it was not able to use, but it is a good learning experience.
View detail
As for Repair, I recommend it
I bought it for the Repair of Race cowl for Saitaniya R25
But Size seems to be small and it was not usable for the Cowl of Saitaniya
I think it can be used for any manufacturer's cowl if the size is right
You should check the Size before you buy
View detail
I am satisfied with the finishing condition.
Although it was exclusively for ZrX1200DAEG, I was uneasy until product installation, but I did Fit with no fault, I did Fit with Exactly.
I thought that Double - sided Tape attached to attachment was few, so I used the same 3 - M Double - sided Tape additionally.
I am still using it, but I do not have any dissatisfaction. I hope the Cost performance is a little better.
View detail
I care about Cut
I was worried about replacing OEMPad's Small size. First of all it is easy to peel off the OEMPad, but I had a hard time peeling off the Double-sided Tape. Be sure to remove Tape etc. I think that it is better to prepare Spray. Kerosene and Thinneretc. It will also discolor the painting.
I think that Double - sided Tape that is attached enough to stick to the outer circumference of the back side of the attached double - sided tape attached is not enough a bit. If you are worried you have to purchase additional.
The appearance changed with impression of twill carbon carbon, and the worry about scratches to Tank was also gone, but the finish of R part near the filler opening is Quantity : Pair (for Left and Right) It is not symmetrical, full of feeling cut by hand.
It is ☆ 5 if you can finish the outer circumference a little better.
View detail
as for Ninja1000 [ green ], a Tank also becomes green, as for 2012 MODELs -- -- after attaching this Parts, it has not taken to it individually. At 2011 MODEL, I think that it is good by touch of the fashion which Melted, without being cons
as for Ninja1000 [ green ], a Tank also becomes green, as for 2012 MODELs --
-- after attaching this Parts, it has not taken to it individually.
At
2011 MODEL, I think that it is good by touch of the fashion which
Melted, without being conspicuous since a Tank is black.
View detail
I feel that a number of double-stick tape is few. I think that it may be better if it has more 1mm thickness. It floats later very often. It was regrettable that the position which has not stuck the tape sounds. It is a product with high satisfaction in
I feel that a number of double-stick tape is few. I think that it may be better if it has more 1mm thickness. It floats later very often. It was regrettable that the position which has not stuck the tape sounds. It is a product with high satisfaction in which it is dramatically effective as a function of a protector, and the texture of twill is very beautiful. So, cheapness of an attached tape is regrettable... View detail
Although there is also touch that some are [ the adhesion of a tank top side ] bad, the crack of a tank is kept firmly. Since it is liking that the edge was effective to a slight degree, a design feels it as unsatisfactory. Moreover, I think that
Although there is also touch that some are [ the adhesion of a tank top side ] bad, the crack of a tank is kept firmly.
Since it is liking that the edge was effective to a slight degree, a design feels it as unsatisfactory.
Moreover, I think that there should just be some which can also protect a tank side.
View detail
First, a supplementary seal is glad. Although there is presence in this body color too much at the beginning of purchase and it was felt as kana, this presence will be good touch if it gets used. Should the mounting arrangement just be not double-
First, a supplementary seal is glad.
Although there is presence in this body color too much at the beginning of purchase and it was felt as kana, this presence will be good touch if it gets used.
Should the mounting arrangement just be not double-stick tape but a magnet?
View detail
Fits: SUZUKI GSX1300R GSX1300R HAYABUSA(GSX1300R HAYABUSA)
The tank got damaged and it purchased to prevention. The accuracy about which it was worried was satisfactorily attached to the beauty. However, the crevice ? is in a product and there are some parts which Shiloh of a lower tank is transparent and
The tank got damaged and it purchased to prevention.
The accuracy about which it was worried was satisfactorily attached to the beauty.
However, the crevice ? is in a product and there are some parts which Shiloh of a lower tank is transparent and are in sight.
Since the product value as a dress-up up is also a certain thing, I want the neighborhood to think and it is *3.
(Although it is a manual-operation reason ..)
View detail
Fits: SUZUKI GSX1300R GSX1300R HAYABUSA(GSX1300R HAYABUSA)
The texture of carbon is also high and is the matching ~ splendidly also in R form of a tank. One with regrettable one is greatly thrown into relief with CLEVER WOLF in the central lower part, and it is just going to divide tastes. As soon as exte
The texture of carbon is also high and is the matching ~ splendidly also in R form of a tank.
One with regrettable one is greatly thrown into relief with CLEVER WOLF in the central lower part, and it is just going to divide tastes.
As soon as exterior equipment uses a logo as a seal, I want you to carry out it.
View detail
GSX-R 1000K4 is followed and it is 2 times Sakka's purchase. Since K7-K8 had the complicated tank form of a protector attachment location compared with K4, even if it stuck how and adjusted the location, it was not able to stick with PITARI without th
GSX-R 1000K4 is followed and it is 2 times Sakka's purchase.
Since K7-K8 had the complicated tank form of a protector attachment location compared with K4, even if it stuck how and adjusted the location, it was not able to stick with PITARI without the crevice (a crevice remarkable [ neighborhood which is a stage ] is made).
For the reason, using the thicker commercial tape, the tape was arranged and stuck on the part which can do a crevice so that a crevice might be filled.
Since it can cover as a function surface to the location in which it hides with a sheet, a wound which a belt and the metal fittings of a zipper hit and is made can be blocked thoroughly.
View detail