Reviews
Fits: KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4)
Easy-to-grasp Clamp
It opens effortlessly with my index finger and thumb without the need for Pliers or Radio pliers. I found them very easy to use. The price is also good because it's two for the price of one. View detail
Safe for Hose Tightening
This Hose Band can be tightened on both Oil line and Water line. View detail
Hoose Band for peace of mind
Quantity:1 Set of 10pcs. is good value for money. It is easy to tighten and loosen with just one screwdriver and is durable and resistant to rust. View detail
Good quality.
Most of the Case can't be used even if it differs by 1mm. w
Make sure to measure properly and use the appropriate size.
It restores the original diameter even if you spread it out all the way with a Rajpen.
It's obvious, but when you buy something cheaper, this is what you get.
No problem with this product.
View detail
The price is per piece. The size is accurate. View detail
11mm OD won't fit?
I used it on a Fuel Hose with an inner diameter of 6mm× outer diameter of 11mm, but the leak did not stop. View detail
Variation
I purchased this product to replace the carburetor OH and surrounding hose on my SEA BASSDF200 DJEBEL because it saved me a lot of time and effort compared to picking up OEM parts one by one and I could use the extra parts on my other motorcycle. I'm glad I did because I've used them on other motorcycles. View detail
Easy to use, but be careful not to lose it
I used it for Fuel line of TZr50R.
The deciding factor in the purchase
I was looking for a Clip that was easy to remove as I expected to remove the Fuel line a few times for adjustment and cleaning.
I decided to buy it because it was relatively inexpensive and had a good Impression rating.
In addition, since Clip of this Type was used in another part from the time of purchase, I thought it would be able to use it without a problem.
[Impressions of using it]
I thought the part of the handle was Large and certainly easy to pick up.
However, when I was pinching it with Tweezers to test it because the spring force was working in a certain way, it flew away 1pc. somewhere...
When you first put it on, for example, you can spread it out enough with your hands, which is better.
I think that the performance as Clip is reasonably good because there is no leakage especially.
Products compared
I compared this product with KITACO's and DRC's Clip. I bought this product because it was the top in the popularity order and it was inexpensive and had a good reputation.
【Review】
I thought it was good because it was easy to pick up and use. However, it is small and easy to lose.
It would be easier to find if the clip itself was colored....
View detail
Choose your size carefully
I was looking for a Hose clip to use for the Hose on my Brake Reservoir tank.
I'm not sure if it's called Size (it's a pain in the ass to measure), so I went on a hunch and bought a φ13mm.
The deciding factor in the purchase
The price was low and the Quantity:1 Set of 2pcs. so I thought it was Exactly for the Hose of the Reserver tank.
The one I'm using now is rusting, so I thought it would be nice to have it painted Black to help prevent any rusting.
[Impressions of using it]
It seems to work fine as a Band. It is a low price but solid.
I was going to use it for the Reservoir Tank Hose on the Rear of my TZr50R, but the upper side is a bit too large, and the lower side is a bit too small... (probably top φ14mm, bottom φ12mm or 11mm)
It seems to be able to use it for the upper side, but because the lower side seems to be severe, I decide to buy it again after measuring that side firmly! (Sweat)
I also had a little trouble because the Pliers I have are cheap 100s and not exquisitely open enough.
I'm not saying it's the fault of this product, just that you should buy good Pliers.
【Review】
I was satisfied with both the ease of use and the texture of the product.
Please measure the size of the clip before buying. (Obviously.)
View detail
I'll take this over Hose Band.
I put it on the car which is under construction. The size can be used for mesh hose, so it is more luxurious than just using Hose Band. I wish it was cheaper.... View detail
I think 13mm is OEMsize.
I used it on my DAYTONA Reservoir Tank Hose!
Size is 13mm
It was ExactlySize.
Abrupt angle will bend
View detail
It tightens securely.
The grip is wide enough to prevent leakage of the fuel line hose. View detail
Thin Hose fixation.
Purchased for fixing Hose.
If it's a weird material, it's a part that will rust quickly, but this one is still Large sturdy even after 2 years.
The meat removal on the Band is thin, but there is almost no bite to the Hose.
View detail
Ordinary Clip
I bought it for the Fuel Hose mounting area.
As long as the outside diameter of the hose is correct, you will not have any problems.
I'm surprised that it doesn't rust even after 3 years in blue heaven. Is it because of the surface treatment?
The claws of this type of Clip are small and hard to hook. It's a little bit sluggish, but that doesn't mean it's bad.
View detail
It looks smaller than the Size sign.
10.Plating and texture are good. View detail
Hmmm...
I bought it to stop the brake hose, but the screw does not go through as it is. It seems to have to be bent a little and used again. When it is bent again, the black part (Coating of Rubber?) has been lifted. The price seems to be high for such a thing. View detail
Good to have in stock.
I bought the Meteretc. without any commitment to it.
I'm a little disappointed that it's not in stock.
It's even better if these Parts are in stock and available for immediate delivery.
View detail
For HARLEY!
I'm using it on my '06 XL883R. it was my first time to tweak a Harley, but it looks like this type is used in many of the Horse clamps. I didn't mind anything, but I got the same type. I don't have any problem to use this type of Clamp. View detail
Okay!
I recently overhauled a separate Master Cylinder, so I bought it to replace all the replaceable parts with new ones.
It's easier to have Pliers, as it's quite tough to do with just your fingers.
View detail
It's neither good nor bad.
I lost the hose clip when I replaced the hose when I did an overhaul of the masterpiece. I bought it because I did.
It was cheaper to buy it at Home Center, but it was a hassle, so I bought it here!
View detail