Reviews
Fits: HONDA CB300R, HONDA CB150R, HONDA Monkey125 (MONKEY125), HONDA GROM (Grom 125), HONDA CB125R, HONDA CBR250R, HONDA CB250R
Lever Replacement
A little cheap. It feels uncomfortable when your finger hits the inner groove. View detail
Fits: SUZUKI GSX1300R GSX1300R HAYABUSA(GSX1300R HAYABUSA)
I think it should be a little shorter.
The quality of the product itself is good, but when installed, it directly hits the exhaust pipe, so countermeasures are necessary.
4.I installed it on a 5cmLowdown body, but I don't feel that it deepens the bank angle when stopping too much,
I think it would be better if it were shorter.
Overall, it is not very effective for the price, and if you consider it a return on investment, you may not want to do it.
View detail
Fits: KAWASAKI Z900RS, KAWASAKI Ninja 1000 (Z1000SX), KAWASAKI Z1000 (water-cooled)
usually
I can't judge if it is good or bad because I haven't compared it with OEM. I installed the parts for appearance rather than practicality, but it is not bad. However, if I wanted, there are a lot of advanced parts on the top, and I am thinking of replacing them. View detail
Fits: SUZUKI GSX1300R GSX1300R HAYABUSA(GSX1300R HAYABUSA)
It can be used for New ModelGSX1300R HAYABUSA.
I bought this after checking that the part number had not changed from the second generation GSX1300R HAYABUSA.
I think the strength is not a problem because we sell OEM Product by processing
It is said that it is 2cm short, but when I put it side by side, I can't feel the difference so much.
You can try to replace it. 'A little more Motorcycle leaning, perhaps? It was about the same change.
Unfortunately, the angle of the welded steel plate is not correct and the gap with the ground is too large.
It might be better to have a shop that can weld make a custom one for you!
View detail
Seat Shape Caution
In my case, the tip of the seat is narrow, so Magic tape can not reach the seat. In my case, the tip of the seat is narrow, so the Magic tape could not reach and only the back side was fixed.
As for the effect, my butt usually starts to hurt after about an hour and a half, but when I put the Gel Zab on, the time it takes for my butt to hurt has doubled.
It is a pity that the installation method is not good enough because it is effective.
View detail
We have not installed yet.
I am in the air as it is wearing Lowdown Seat. I will post again when I install it in the future.
I was wondering if more wonderful products would arrive but it was just a punch in Plate. Although the hole position may be exquisite. Since it is with vehicle type Exclusive Design, we will wait for change after installation.
View detail
I thought whether to become in play [ of handle + weight ] rather than having called it in play [ of handlebar weight ], but the effect until it pays honest money was not acquired. a handle position, vibration absorption, and appearance -- which serve
I thought whether to become in play [ of handle + weight ] rather than having called it in play [ of handlebar weight ], but the effect until it pays honest money was not acquired.
a handle position, vibration absorption, and appearance -- which serves as not quite satisfactory evaluation.
About vibration, the direction after handle exchange feels it large.
Kana which could be normal!!
View detail
It purchases to DUCATI 900ss (1992). Since it had changed into the single seat instead of a normal seat, it was made the type put in a sheet. It not only puts in under a sheet, but if the sponge like 5 mm thickness is put from on this product, put
It purchases to DUCATI 900ss (1992).
Since it had changed into the single seat instead of a normal seat, it was made the type put in a sheet.
It not only puts in under a sheet, but if the sponge like 5 mm thickness is put from on this product, putting into inside will not be clear anymore.
Although the hips became painful at about 200 km before wearing, after wearing became Iker about 300 km.
Having considered a price and time and effort, it was thought in the sheet specialty store that the way taken out to work was a correct answer.
Are they the goods for the persons who like work?
View detail
Probably, it will be more certain to try acquisition of Colet and the comfortable sheet that will be sold by the sheet special manufacturer if it purchases. . . A small fellow's wearing and the difficulty of fitting are high, it has the re-cov
Probably, it will be more certain to try acquisition of Colet and the comfortable sheet that will be sold by the sheet special manufacturer if it purchases.
.
.
A small fellow's wearing and the difficulty of fitting are high, it has the re-covering technology of about the same sheet as pro with it, and, moreover, dishing up of the shaving & small fellow of urethane (ANKO) is still more difficult.
.
.
After all, it asks for the benefit of a pro's technology and strikes a sheet repair shop's gate.
.
.
It completely had such our bitter experience, and only wasted time and a labor rather than cost effectiveness so and so.
.
.
It has truly and is TOHOHO.
.
.
Such a bitter experience.
.
.
The purchase of the replace sheet manufactured seriously thinks that it is a short cut to attainment of a comfortable sheet.
.
.
First of all, by the low rebounding material of only one sheet, if a comfortable sheet is obtained, the pure sheet should already have lived luxuriously.
.
.
A comfortable sheet cannot be built by the low rebounding material of one sheet.
.
.
Yes, we consider.
.
.
View detail
Since the path of clamp part knurling was large, the attachment to a clamp suffered troubles. I would like to ask you for management of a path exactly.
Since the path of clamp part knurling was large, the attachment to a clamp suffered troubles.
I would like to ask you for management of a path exactly.
View detail
This time, the GEL-ZAB S addition was carried out at the sheet of VFR800. Since it has ridden on CBR600F4i (pure : rice cracker sheet) for a long time from the first. Although there was no complaint in the sheet form and hardness of VFR, it asked
This time, the GEL-ZAB S addition was carried out at the sheet of VFR800.
Since it has ridden on CBR600F4i (pure : rice cracker sheet) for a long time from the first.
Although there was no complaint in the sheet form and hardness of VFR, it asked for much more pleasure.
It is a usage feeling.
It went for day's trip touring with a mileage [ total ] of 660 km by the state where it equipped with this.
Surely, the fine vibration from under the hips decreased.
However, the pain of a buttock which will also have how to ride and transit time, and the pain of the waist were not necessarily lost at all.
However, time until it becomes so thinks whether it became long.
(Highway cruising and 3-hour continuation are also margins) It seems that it was effective when thinking so.
Moreover, as a subeffect equipped with this, the sheet surface became soft and the slide of the buttock on a sheet decreased.
Even if it hangs gaily, a center-of-gravity location does not shift.
All that matters is change of appearance.
It is made hard to be conspicuous by building in the sheet back side.
I think whether it was the thing to say and which was borne by the purpose.
It will be conspicuous, however it may see so that it can grasp from a photograph 4 piece eye.
It may be [ of the sample photographs of the package of this product ] congenial for the sheet of a street system with it. [ the thick and sheet surface and ] [ flat ]
As the notes at the time of purchase.
Be careful of not being put on the market in a form like product sample photographs.
The actual product configuration has become like an attachment photograph 2 piece eye.
Because it is a reason for it having been square and having become a sheet, thanks to this.
This needs to be permissible.
Since it is not an ineffective translation anyhow.
If a motorcycle is operated, I will think that it is good for the direction which suffers damage to the strongest at the hips and the waist, and the direction which wants to change a sheet into the state which is not common.
View detail
I want those who are using GERUZABU by high-speed SA to come to hear a using feeling, and a big scooter purchases GERUZABU S only purchase by ? which a beam stops due to a trunk and cannot turn an ingredient. A hang needs wearing for using well the tu
I want those who are using GERUZABU by high-speed SA to come to hear a using feeling, and a big scooter purchases GERUZABU S only purchase by ? which a beam stops due to a trunk and cannot turn an ingredient.
A hang needs wearing for using well the tucker where he was also able to do it simply over about 2 hours.
Effect ... Existing 縲?is! Head family GERUZABU of the touch and the effect which are not like GERUZABU heard in the talk that the thickness of a sheet place reduces an effect by half is recommended.
View detail
although value suitable for a price thought the existing kana when it was short distance -- A long distance ... it hardly changes to the time of normal -- the hips -- it is painful. It is the hot insulation power of this GERUZABU about it having been
although value suitable for a price thought the existing kana when it was short distance -- A long distance ... it hardly changes to the time of normal -- the hips -- it is painful.
It is the hot insulation power of this GERUZABU about it having been worrisome except [ its ].
Only when having placed under the blazing sun, it was a sheet of normal and it straddles, it is felt hot and gets used to temperature soon, but even if it passes till when, temperature will not fall, but this GERUZABU has been felt hot quite for a long time.
It will feel uneasy [ some ] with whether a winter season becomes with this sheet reverse and cold for the time being.
View detail