Reviews
Fits: SUZUKI GSX-R600, SUZUKI GSX-R750, YAMAHA MT-07, YAMAHA MT-09, YAMAHA MT-10, APRILIA CAPONORD 1200, APRILIA DORSODURO1200, APRILIA TUONO V4 1100 Factory, BMW F800GS, BMW F800R, BMW R1200GS, BMW R1200GS Adventure, BMW S1000R, BMW S1000RR, DUCATI DIAVEL, DUCATI HYPERMOTARD1100EVO, DUCATI HYPERMOTARD1100EVO SP, DUCATI HYPERMOTARD1100/S, DUCATI HYPERMOTARD796, DUCATI HYPERMOTARD821
Great looks. as a cap bolt….
Do not over-tighten or apply Screw lock agent by mistake, as the material is material and will quickly lick the hex holes.
I want to install it firmly because it is for fixing Stay which supports important parts around Handlebar ….
View detail
Fits: DUCATI SUPERBIKE Panigale V4 S, DUCATI SUPERBIKE Panigale V4 R, DUCATI SUPERBIKE Panigale V4, DUCATI SUPERBIKE 955 Panigale V2, DUCATI STREETFIGHTER V4, DUCATI STREETFIGHTER V4 S
Different quality from JAPAN
It looks cool at a quick glance, but the surface is full of bubbles (bubbles or Garbage?) and the quality is quite poor. View detail
Fits: DUCATI STREETFIGHTER848, DUCATI STREETFIGHTER S, DUCATI STREETFIGHTER
Doesn't seem to fit Ducati Streetfighter S2012…
When installing the right side footpeg, the footpeg cannot be installed due to interference with the exhaust guard, even if the included spacer is used.
If it is an imported car, the exhaust system may be small and may not interfere;
I tried to replace the brake lever with OEM parts, but it interfered with the clutch box and the angle was a little strange.
The Left Side installation was fine, but the screw thread on one of the push rods was not cut properly, so it was difficult to install.
View detail
quality
It is very soft. I had to do some additional work on the hole, but it looks like it is probably a 5000 series in terms of feel when machined.
Also, the surface treatment is not hard anodized, so be careful of scratches when installing.
Position-wise, I think it depends on the type of car and the size of the person, so 3 stars.
View detail
Good product, but expensive.
In terms of usability, I think oil pans such as SIGNET are definitely better. I think it was a mistake to buy it. View detail
![Frame Cap Set MV AGUSTA F4[Frame cap sets MV Agusta F4]](https://img.webike-cdn.net/catalogue/images/37768/TT334B_TT334G_TT334R_TS.jpg)
Fits: MV AGUSTA F4 1000 13-15, MV AGUSTA F4 1000R, MV AGUSTA F4 RC, MV AGUSTA F4 RR
I can not use it.
The goods are TrussFrame's Bolt fixed place (Quantity : Pair (for Left and Right) 2 places in total, 4 places in total) and Parts covered in the Shaft section of Swingarm.
Cap attached to the underside of the Frame makes Small O-ring attached, you can not install it with a skusca even if you close Bolt.
Also, although the Swingarm department can be installed, the Bolt position is bad and slightly deviates downward.
Parts I think that it is an expensive class from points, but this precision can not be used.
View detail