Reviews
Extremely common products
The Vinyl bag, which was only slightly touched by the residual heat of the exhaust pipe, melted and leaked waste oil when it was tied up with the tie wrap. It would be appreciated if you could change to a Vinyl bag with higher heat resistance.
Into
View detail
historical legacy
Wow, so many people writing imprements on just Nozzle!
When I was on my 2nd, I kept a 1 liter can at the fueling port in the back of the car. Replenishment." The best time to do this was when I was
We didn't weigh the Levels exactly, and it was routine to dispose of the entire can after 3 or 4 refills (and it was free back then).
On the other hand, when pouring more than 3Liter in 4st Engine oil change, there is not much Merit.
It would be much faster to transfer the required amount to a jug or use Bellows long funnel...
But there is something quaint about attaching it to the mouth of the G1 one at a time and waiting for the last drop to fall out.
I think it is a gem that has supported Sunday Motorcycle.
View detail
Nozzle
I think the product is good.
I changed the engine oil for the first time in about 10 years.
I was very enthusiastic, but the oil leaked out of the BWS125 because the place where the engine oil is put in is at an angle.
Next time I will use Funnel. But my hands get dirty too, so I may leave it to Shop.
View detail
For use when replacing Oil
I purchased it at the same time as Oil for oil change work.
We selected this product from LINK on the Oil Purchase Page, which seemed to have good cost performance.
It worked fine
View detail
It is a classic.
It is a standard for waste oil disposal, and the Tie Wrap and Vinyl gloves included in the package are convenient. I would appreciate it if you could make it a little smaller and cheaper if possible. View detail
A little cheaper would be nice
Used for Oil and Filter replacement on VTR250-Type LD. It was difficult to use due to the narrow clearance between the ground and the oil pan. The capacity was enough, but the absorption was not so good because of the Dustcloth inside. I wonder if it is possible to make it with the same capacity and a little height. View detail
Used in Oil Replacement
The product is as good as it looks.
Basically, OEM type Oils do not have Nozzles on the Bottle portion, so we use them in that case.
It is neither particularly good nor bad.
As others have said, it seems expensive to say it is expensive.
View detail
It was so-so.
[How is it used?
The end is a bit of a tight fit.
Was the one you received as per Image?
Street Image
How was your experience with it?
Oil leaked after I was done.
[Points to note]
I'd like to see a double Vinyl.
How did it compare to other products?
So so
Other items that would be helpful
Installation points and hang/Items to buy together/ Opinions and requests to the Manufacturer
View detail
Vinyl gloves included
[How is it used?
I used it once.
How was your experience with it?
It comes with Vinyl gloves, so you can use it without getting your hands too dirty.
The box is not that tall, so it could be used for Large-bodied Motorcycle.
How did it compare to other products?
It is rare that Vinyl gloves are included.
[Points to note]
Not particularly
View detail
Oil change essentials
This is a necessity for Oil replacement.
It is convenient to throw it away as is after use.
View detail
I buy it all the time.
The gloves are very helpful and keep my hands clean. View detail
It can be used normally
Used to treat engine oil. It can be used without any problem. The price is a little higher than similar products from Home centerretc. but I think it is possible if you get free shipping on top of your other purchases. View detail
good on cost
I purchased this product for my car's first Oil change. I referred to various articles and found that this product was recommended. I thought this would be the first one I would buy because of its good cost performance.
It is very convenient to use and I think this will be a Repeat in the future.
View detail
For Maintenance
It is a little more expensive than Home center, but I bought it because I had a Point expiration date.
If you don't normally have Nitrile gloves, it's a good idea.
View detail
It can be used normally
Used to be in the Oil department. Feel free to bring your own." I used to have it in my office, but I don't see it anymore. If you don't have it, you can live without it, but if you do have it, it makes your work a little easier.
This was the first time I paid for this product, but I was able to work with it without any spillage of oil on the mouth of the can.
View detail
Friends of Oil Exchange
Essential Items for Oil Replacement
Thanks for all your help every time.
View detail
4.Is it tough to put in 5L?
4.It is listed as 5L, but I only put in less than 4L and it was pretty tapped.
It seems like it would be better not to put it in until Limit.
It would be nice to have work gloves and a sealed inHemp palmac included.
View detail
This is still good enough.
[How is it used?
It is used when changing Oil in CUB110.
How was your experience with it?
They say it is for 2L, but it seems to be just right with a little over 1L in it.
When I used it before, somehow it overflowed, so I was worried about the waste oil absorbent inside. This time there was no problem.
Maybe you happened to pull a HaGap last time.
How did it compare to other products?
Personally, I prefer Emon, as I feel the Oil absorbent is softer and absorbs more instantly.
In terms of price, though, I'm buying more of this product.
[Points to note]
It is a good idea to unwind the Oil absorber beforehand.
View detail
Nozzle size should be selectable.
I used it for refueling oil for my Honda GR2's 1L cans. The screw type attachment to the oil cans allows for secure attachment and no oil leakage during refueling. Nozzle angle can be changed. When removing the nozzle from the can, a little bit of oil from Bellows leaks out, so I thought it would be better to use Dustclothetc. to remove it. The size of the nozzle and the amount of oil poured into the nozzle will vary depending on the situation, so it would be useful to have an attachment etc. that can change the diameter of the nozzle when refueling directly with this nozzle. View detail
Toilet paper on a suitable ball is fine.
[How is it used?
2L is enough to replace oil in Ninja 400.
How was your experience with it?
I thought it would be easier to work with if it was a little flatter.
It's convenient to have and can be used as usual, but I wanted to keep the cost down as much as possible since I change the oil so often, so I started using a Garbage bag and a roll or two of Toilet paper in a small ball to dispose of the waste oil.
Since I use NetShop a lot, I no longer use this product because I can keep the price under 100 yen since I have a mountain of DanBall.
If it's a hassle, you can buy this product, and if not, you can get by without it.
[Opinions and requests to Manufacturer
I would like to have something with less height because it easily interferes with Under Cowl.
View detail